Instruction Manual

53
from injuries.
Remove the accessories from inside.
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning
agents recommended.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product three hours after running your product as stated in this
manual.
EXTERNAL CLEANING
Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and lighting section
while cleaning.
Clean the door gasket by using clean soapy water only.
MAINTENANCE
Clean the dust accumulated on the condenser, which is on the back part of your device
with the help of a vacuum cleaner or a dry brush after unplugging the device. Repeat
this process a few times in a year.
TRANSPORTATION OF YOUR PRODUCT
Pay attention to the following considerations if you do not use your product for several
reasons (such as vacation, trip etc):
If you do not use it for a short time:
Leave your product in operating state.
If you do not use it for long time and want to shut it down:
Consume the foodstuff inside your product and empty it.
Unplug the power cord from the outlet.
Apply defrost and internal cleaning steps in this manual.
Dry inside of the product thoroughly. Darkening may occur in the product which is not
dried.
Leave the product with door open.
Before transportation:
Unplug your product from the grounded outlet.
Carry out defrost operation.
Carry your product at normal using position. Do not carry horizontally, vertically, tilted
or with the door open.
Protect your product from the impacts while carrying. Do not carry your product when
it is plugged in or full.
In order not to cause any accident or for preventing the product to get damaged by
falling or sliding, secure your product to the vehicle during the transportation.
NOTE