Instruction Manual

54
TROUBLESHOOTING
The failures and solutions stated in this section can be performed easily by yourselves,
however consult the JOCEL Technical Assistance, if these suggestions do not solve your
problem.
CAUTION!
Intervention to any failure that may occur in your product must be carried out by
Technical Assistance.
Any intervention that may be done by you, or non-authorized person, may harm you,
because invalidate the product guarantee and can cause material damage (fire, etc..).
In case of any failure, consult the Technical Assistance.
Consult the JOCEL, to order spare parts.
For any questions and during the warranty period, please contact JOCEL.
TROUBLESHOOTING
POSSIBLE SOLUTION
RESULT
The beverage cooler is
not working. (No sound
or only fan sound
comes from the
product.)
It may be due to the
thermostat not plugged in.
The fuse may be blown or
broken down.
The condenser grids may be
obstructed or get dirty.
It will run again when
reached to the suitable
temperature.
Insert the plug properly.
Consult to the JOCEL
Technical Assistance.
Clean the condenser grid.
The product internal
temperature is high.
External ambient temperature
is very high or it’s with the
wrong thermostat setting.
The ventilation grids (very
close to the back wall) are
obstructed or blocked by an
object.
It may have been expose to
excessive external wind.
The Condenser grids are very
dirty.
Move the beverage
cooler to a place where
the external temperature
is lower.
Adjust the temperature,
like the recommended.
Clean in front of the
ventilation grids.
Prevent the wind.
Clean the condenser
grids.
The product internal
temperature is very low.
Wrong internal thermostat
setting.
Re-set the thermostat.
High degree of
sweating on the glass
and inside the device.
Water discharge hole may be
obstructed when sweating is
seen inside the beverage
cooler.
In glass sweating on the
other hand, current external
ambient humidity is over
65%.
Clean water discharge hole.
With regards to the high
humidity, you can move
your beverage cooler to an
environment with less
humidity.
The power values of the lamps and LEDs used in your products are indicated in the section
where they are inserted and may vary depending on the product. Only an accredited
technician can replace lamps and LEDs used in your product.