Operator's Manual
Table Of Contents
- Introduction
- Safety
- Recognize Safety Information
- Understand Signal Words
- Follow Safety Instructions
- Practice Safe Maintenance
- Use Steps and Handholds Correctly
- Handle Electronic Components and Brackets Safely
- Use Electronic Display Properly
- Prevent Electrical Shock and Fires
- Avoid Exposure to High Radio Frequency Fields
- Avoid Electrical Power Lines
- Avoid Electrical Power Lines
- Safety Labels
- Regulatory and Compliance Information
- System Overview
- Component Overview
- Setting Up–Configuring RTK Radio 450
- Troubleshooting
- Specifications
- John Deere Service Literature Available
- John Deere Service Keeps You On The Job
Practice Safe Maintenance
TS218—UN—23AUG88
Understand service procedure before doing work. Keep
area clean and dry.
Never lubricate, service, or adjust machine while it is
moving. Keep hands, feet, and clothing away from
power-driven parts. Disengage all power and operate
controls to relieve pressure. Lower equipment to the
ground. Stop the engine. Remove the key. Allow
machine to cool.
Securely support any machine elements that must be
raised for service work.
Keep all parts in good condition and properly installed.
Fix damage immediately. Replace worn or broken parts.
Remove any buildup of grease, oil, or debris.
On self-propelled equipment, disconnect battery ground
cable (-) before making adjustments on electrical
systems or welding on machine.
On towed implements, disconnect wiring harnesses
from tractor before servicing electrical system
components or welding on machine.
Falling while cleaning or working at height can cause
serious injury. Use a ladder or platform to easily reach
each location. Use sturdy and secure footholds and
handholds.
DX,SERV-19-28FEB17
Use Steps and Handholds Correctly
T133468—UN—15APR13
Prevent falls by facing the machine when getting on and
off. Maintain 3-point contact with steps, handholds, and
handrails.
Use extra care when mud, snow, or moisture present
slippery conditions. Keep steps clean and free of grease
or oil. Never jump when exiting machine. Never mount
or dismount a moving machine.
DX,WW,MOUNT-19-12OCT11
Handle Electronic Components and
Brackets Safely
TS249—UN—23AUG88
Falling while installing or removing electronic
components mounted on equipment can cause serious
injury. Use a ladder or platform to easily reach each
mounting location. Use sturdy and secure footholds and
handholds. Do not install or remove components in wet
or icy conditions.
If installing or servicing a RTK base station on a tower or
other tall structure, use a certied climber.
If installing or servicing a global positioning receiver
mast used on an implement, use proper lifting
techniques and wear proper protective equipment. The
mast is heavy and can be awkward to handle. Two
people are required when mounting locations are not
accessible from the ground or from a service platform.
DX,WW,RECEIVER-19-24AUG10
Use Electronic Display Properly
Electronic Displays are secondary devices intended to
Safety
05-2