PECO PECO OWNERS MANUAL MODEL 06621213 - 16 FOR A JOHN DEERE 717 & 727 UNIT MODEL #717 Z-TRAK 48” DECK & 727 Z-TRAK 54” DECK P# Q0285 CONGRATULATIONS AND THANK YOU FOR BUYING THIS PECO LAWN VACUUM. Your new PECO Vac has been engineered and manufactured to PECO’s high standards for safety, quality, dependability, and ease of operations.
PECO WARRANTY PECO Limited Warranty for New Products A. WHAT IS WARRANTED? PECO extends the following warranties to the original purchaser of each new PECO consumer product subject to the following limitations. 1. PRODUCT WARRANTY.
PECO SAFETY Outdoor Power Equipment Institute Recommendations WARNING TO PURCHASERS OF INTERNAL COMBUSTION ENGINE EQUIPPED MACHINERY OR DEVICES IN THE STATE OF CALIFORNIA: The equipment which you have purchased does not have a spark arrester muffler. If this equipment is to be used on any forest covered and brush covered land or grass covered unimproved land in the state of California, the law requires that a spark arrester muffler be installed and be in effective working order.
PECO PARTS LIST REF. NO. 01 1 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 PART NO. E1039 E1113 J6006 ****** E6009 A602 OR A638 J6011 ****** #HB0151 A0452 A0971 B0001 A0060 B2220 B3727 B0064 B0026 MODEL 06621213 - 16 DESCRIPTION BOOT (48” DECK) BOOT (54” DECK) 7”-8” HOSE CLAMPS 8” x 32” LOWER HOSE 8” BLOWER CONE 5.5HP/BLOWER/BLADE ASSEMBLY 1 6HP/BLOWER/BLADE ASSEMBLY 5”-6” HOSE CLAMPS 6” x 30” UPPER HOSE HARDWARE BAG TOP FRAME ASSEMBLY MOTOR MOUNT ARM ASSEMBLY BOOT PLATE THROTTLE KIT ASSEMBLY (5.
PECO PARTS DIAGRAM 06 12 09 08 15 07 13 14 04 10 16 03 11 02 01 05 MODEL 06621213 - 16 JOHN DEERE 717 & 727 PECO 5
PECO ASSEMBLY STEP 1: Place the left main frame side leg (A) onto the rear sides of the mower. Secure the left main frame side leg (A) to the rear of the mower using the mower’s preexisting bolts (B). After the left main frame side leg is secure follow the same instructions to mount the right main frame side leg. Use the picture below for more detail. A B STEP 2: Place the outer motor mount tube (A) underneath the left & right main frame side legs (B).
PECO ASSEMBLY STEP 3: A Place the top frame assembly (A) onto the left and right main frame side legs (B). Secure the top frame assembly (A) using (4) 3/8”-16 x 1” hex bolts (PN#K1191) (2 per side) & (4) 3/8-16 flange nuts (PN#K1215) (2 per side). Use the diagram to the right for more detail. B BOLT LEGS ON OUTSIDE OF FRAME STEP 4: On the right end of the outer motor mount tube (A) slide the motor mount arm assembly (B) in. Secure using (1) detent pin (PN#J0248).
PECO ASSEMBLY STEP 7: B The ears of the cone (A) should fit underneath the two threaded bosses on the blowerface (B). Secure with (2) 5/16”-18 x 2” hex bolts (PN#K1159). Use the diagram to the right for more detail. A TIGHTEN ALL NUTS AND BOLTS! IMPELLER BLADE REPLACEMENT TO REMOVE: First remove hex bolts from hub, then screw the bolts into threaded holes to remove old blade. (This will push impeller off the hub.
PECO ASSEMBLY STEP 8: i f Place the hose clamps over each end of the 6” hose (A). Attach one end of the hose onto the blower housing (B). Attach the free end of the hose over the inlet (C). Tighten the hose clamps. Use the picture below for more detail. C A B STEP 9: Place the hose clamps over each end of the lower hose (D). Attach one end of the hose over the blower cone (E). Slide the free end of the hose over the boot (F) and tighten the hose clamps. Use the picture below for more detail.
MAINTENANCE PECO Your PECO Lawn Vac was designed and built to provide years of service with only minor care. Certain tasks however must be performed to keep it in good operating condition and to avoid costly repairs. This section describes and provides procedures for the necessary care of the Lawn Vac. SCHEDULED CARE CARE REQUIRED Before Each Use Check engine oil. Check all hose connections. After Each Use Clean Collector Box, hoses and engine of all grass and dirt.
PECO TROUBLE SHOOTING Diagnostic Procedures Trouble shooting procedures are provided in the chart below. To use these procedures, first locate the problem below that best describes the trouble you have encountered. Check the possible causes in the list one at a time. Correct any problems that are found and operate the vacuum collector again to verify that you have eliminated the problem. DO NOT attempt any major repairs without first contacting your dealer.
PECO P.O BOX 1197 ARDEN, NORTH CAROLINA 28704 1-800-438-5823 OR (828) 684-1234 FAX-(828) 684-0858 E-MAIL: PECO@LAWNVAC.