Use and Care Manual
3. Push throttle lever up to the full throttle position.
4. Engage mower.
• On models with electric attachment engagement switch: Pull
switch up.
• On models with mechanical attachment engagement lever:
Push lever forward.
NOTE: The mower and engine will stop as the reverse foot pedal is
pressed for hydrostatic transmission or when the transmission
shift lever is moved to the rear slot (reverse) position for
automatic transmission with mower engaged.
5. Disengage mower blades before moving in reverse or stopping
engine.
• Machines with mechanical attachment engagement lever: Pull
lever back.
• Machines with electric attachment engagement switch: Push
switch down.
Using Wash Port to Clean Mower Deck
NOTE: Follow this procedure after each use to prevent buildup and
remove corrosive lawn chemicals.
1. Park machine safely. (See Parking Safely in the Safety section).
GXAL41997—UN—04MAR13
2. Attach quick-coupler to garden hose.
3. Attach garden hose with quick-coupler to wash port (A) on the
mower deck.
4. Turn on water.
5. Start engine.
6. Run at full throttle.
7. Engage mower blades.
8. Flush water under deck for approximately one minute.
9. Disengage mower blades.
10. Stop engine.
11. Turn off water and remove garden hose and quick-coupler from
wash port.
12. Remove quick-coupler from garden hose and store for future use.
Unplugging Mower, Bagger, or Material
Collection System
CAUTION: Do not attempt to unplug attachment with
machine running.
• RRoottaattiinngg bbllaaddeess aarree ddaannggeerroouuss.. SShhuutt ooffff tthhee eennggiinnee aanndd
rreemmoovvee tthhee kkeeyy bbeeffoorree ggeettttiinngg ooffff tthhee sseeaatt ttoo iinnssppeecctt tthhee
mmaacchhiinnee aanndd aattttaacchhmmeenntt..
• TThhrroowwnn oobbjjeeccttss ccaann ccaauussee sseerriioouuss iinnjjuurryy.. MMaakkee ssuurree aallll
mmaacchhiinnee ppaarrttss aarree ssttooppppeedd bbeeffoorree rraaiissiinngg hhooppppeerr ttoopp oorr
rreemmoovviinngg cchhuutteess..
Checking For Plugging While Driving
If grass builds up in front of mower discharge chute, check for plugged
chute or problems with blower assembly (if equipped).
If there is a trail of clippings behind mower or clippings blow to the side,
check for plugged chute, full collector bags, or problems with blower
assembly.
Removing Debris From Inspection Points:
CAUTION: Do not use hands or feet to clear plugged mower
deck or blower assembly. Stored energy can cause blades to
rotate.
1. Park machine safely. Wait for all moving parts to stop before getting
off to inspect machine.
2. Open hopper cover. Check chute outlet.
3. Remove chute from mower deck or blower assembly. Check chute
inlet.
4. Check under mower deck for debris.
Moving Machine by Hand
CAUTION: When the bypass valve is open, the machine will
have unrestricted motion.
• DDoo nnoott ooppeenn tthhee bbyyppaassss vvaallvvee wwhheenn tthhee mmaacchhiinnee iiss
ssttooppppeedd oonn aann iinncclliinnee ttoo pprreevveenntt iitt ffrroomm ggooiinngg ddoowwnnhhiillll oouutt
ooff ccoonnttrrooll..
IMPORTANT: Transmission damage may occur if the machine is
towed or moved incorrectly:
• MMoovvee mmaacchhiinnee bbyy hhaanndd oonnllyy..
• DDoo nnoott uussee aannootthheerr vveehhiiccllee ttoo mmoovvee mmaacchhiinnee..
• DDoo nnoott ttooww mmaacchhiinnee..
1. Unlock the park brake.
2. Put automatic transmission shifter into center position.
Operating
30










