Use and Care Manual

GXAL42028—UN—05MAR13

107 cm (42. in.) mower deck shown

• On 107 cm (42 in.) mower deck only: Push mower engagement

drive cable into clip (M) and hook end of cable spring with

hardware (N) into peg on left side of machine frame.

Installing Mower Deck

1. Park machine safely. (See Parking Safely in SAFETY section.)

2. Put attachment lift lever in the transport position.

3. Slide mower under machine.

4. Put wood blocks under each side of mower deck.

5. Put attachment lift lever in lowest position.

PY21326—UN—19AUG14

6. Fasten rear draft arm (A) and adjustable lift link (B), on each side,

with washers and spring locking pins (C).

IMPORTANT: To prevent clutch damage, make sure front draft rod

is installed correctly. Secure rod with washer and spring

locking pin on the left side of mower deck bracket.

GXAL42030—UN—04MAR13

107 cm (42 in.) mower deck shown

7. Install front draft rod (D) into mower deck bracket (E):

• For D105 models use the hole marked AUTO (shown).

• For all other models use the hole marked HYDRO (F).

8. Secure front draft rod with washer and spring locking pin (G).

CAUTION: Component is spring-assisted and under tension.

Injury can occur if spring-assisted component is released

suddenly.

GXAL42031—UN—04MAR13

122 cm (48 in.) mower deck used for photo purposes.

9. Put mower drive belt on engine drive sheave (H).

• On 122 cm (48 in.) and 137 cm (54 in.) mower decks: Put a 15

mm closed wrench or a socket on the idler sheave nut (I) and

rotate clockwise, moving idler sheave and tensioning arm

toward front of tractor. Hold while installing belt on drive sheave.

Service Mower