Operating Guide

Table Of Contents
APY36190—UN—10JUL20
a. Route cable under mower belt and brake rod and attach
cable spring (K) to idler sheave bracket (L).
b. Pull out on cable (M), align black end of cable with slot in
bracket (J) and release cable into slot. Secure with spring
locking pin (O).
12. Level mower deck.
SR99263,00002F0-19-24JUL20
Installing Mower Deck (48 in and 54 in Mower Decks)
1. Park machine safely. (See Parking Safely in Safety section.)
2. Put attachment lift lever in the transport position.
3. Slide mower under machine.
4. Put wood blocks under each side of mower deck.
5. Put attachment lift lever in lowest position.
APY36191—UN—10JUL20
6. Fasten rear draft arm (A) and adjustable lift link (B), on each side,
with washers and spring locking pins (C).
IMPORTANT: Avoid damage! To prevent clutch damage, make
sure that front draft rod is installed correctly. Secure rod
with washer and spring locking pin on the left side of mower
deck bracket.
APY36193—UN—24JUL20
7. Install front draft rod (D) into mower deck bracket (E) upper hole
(shown).
8. Secure front draft rod with washer and spring locking pin (F).
CAUTION: Avoid injury! Component is spring-assisted and
under tension. Injury can occur if spring-assisted
component is released suddenly.
APY36192—UN—10JUL20
9. Put mower drive belt on engine drive sheave (H). Put a 15 mm
closed-end wrench or socket on the idler sheave nut (I) and rotate
clockwise, moving idler sheave and tensioning arm toward front of
tractor. Hold while installing belt on drive sheave.
10. Remove wood blocks from both sides of mower deck.
11. Level mower deck.
SR99263,000033E-19-24JUL20
Replacing Mower Drive Belt (42 in Mower Deck)
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Remove mower deck.
Service Mower
38