Use and Care Manual

Assembly - 14
ASSEMBLY
Assembly
Charge and Connect Battery
1. Remove and discard the red positive (+) protective cap from the positive
(+) battery terminal.
2. Charge the battery.
• Battery is fully charged at 12.6 volts.
3. Connect positive (+) battery cable to battery.
4. Connect negative (–) battery cable.
5. Apply general purpose grease or silicone spray to terminal to help
prevent corrosion.
6. Slide red cover over positive battery cable.
Check Tire Pressure
Check tire pressure. (See Checking Tire Pressure in the SERVICE
MISCELLANEOUS section.)
Adjust Mower Deck Level (42C and 48TD Mower)
Adjust mower deck level. (See Adjusting Mower Deck Level in the
OPERATING section.)
Check Engine Oil Level
Check engine oil level. (See Checking Engine Oil Level in the SERVICE
ENGINE section.)
Check Machine Safety System
Perform safety system check to make sure the electronic safety interlock
circuit is functioning properly. Perform all tests. (See Testing Safety
System in the OPERATING section.)
Check Transmission Oil Level
Check Transmission Oil Level (see Checking Transaxle Oil Level in the
SERVICE TRANSMISSION section)
c CAUTION: Avoid injury! The battery produces a flammable
and explosive gas. The battery may explode:
• Do not smoke or have open flame near battery.
• Wear eye protection and gloves.
• Never check battery charge by placing a metal object across
the posts. Use a voltmeter or hydrometer.
• Do not jump start or charge a frozen battery. Warm battery to
16°C (60°F).