Use and Care Manual

Service Intervals - 25
SERVICE INTERVALS
MX51461
6. Fasten front of machine at both sides of the frame at point (A) to trailer
with heavy-duty straps, chains, or cables. Straps must be directed down,
forward and outward from machine.
7. Turn off machine and remove key.
MX51447, MX51448
8. Fasten rear of machine at both sides of frame at points (B) to trailer with
heavy-duty straps, chains, or cables. Straps must be directed down,
rearward and outward from machine.
MX51450
If an attachment bar is on the unit, secure the vehicle using the center of
the top bar (C).
Mowing Tips
• Mow grass with throttle lever in the full fast / mow position.
• Mow grass when it is dry.
• Keep mower deck and discharge chute clean.
• Mow with sharp blades.
• Properly level mower deck for a smooth cut.
• Mow grass frequently.
• Use a travel speed that fits the conditions:
• Mow tall or wet grass twice. Cut grass at half desired height – then cut
at desired height.
• Travel slow when mowing tall or thick grass.
• Avoid damaging grass by slipping or skidding machine drive wheels.
Practice smooth control lever movements.
• When performing sharp turns, do not allow inside machine drive wheel
to stop and twist on grass.
Blade Choices
Several types of blades are available for EZtrak mowers:
• 3-N-1 blades. These are general purpose blades that are best suited for
side-discharge operation, but can be used with a mulch cover installed.
They are not designed for optimal performance when mulching. 3-N-1
blades are installed on Z200 series mowers when shipped from the
factory.
• Side discharge blades. These blades are designed for optimal
performance when side discharging.
• Bagger blades. These blades are designed for optimal performance
when used with a Z200 series bagger.
• Mulching blades. These blades are designed for optimal performance
when used with a mulch cover or mulch plug installed.
NOTE: For part number information, see Part Numbers in the Getting
Quality Service section.
Service Intervals
Servicing Your Machine
Please use the following timetables to perform routine maintenance on
your machine.
Park the vehicle safely. See Park Safely in the SAFETY Section.
Service Intervals
Break-In after 8 Hours
• Change engine oil.
• Change engine oil filter.
A
A
B
C
IMPORTANT: Avoid damage! Operating in extreme conditions
may require more frequent service intervals:
• Engine components may become dirty or plugged when
operating in extreme heat, dust or other severe conditions.
• Engine oil can degrade if machine is operated constantly at slow
or low engine speeds or for frequent short periods of time.