Instructions / Assembly

Assembly - 12

Assembly

3. Insert the flow control handle (B) through the gage plate (C). Insure that

the link rod (A) is in the up position and end of link rod is orientated as

shown.

4. Slide the flat grip (D) over the end of the flow control handle (B), as

shown.

MX40579

5. Insert one 5/16 x 2-3/4 in. hex bolt (E) and one 5/16 in. flat washer (F)

through one side of the gage plate (C), as shown.

6. Install one special washer (G), one spring (H), and a second special

washer (G).

7. Install hex bolt assembly through flow control handle (B), one latch

spacer (I), and out opposite side of gage plate (C).

8. Secure assembly with one 5/16 in. flat washer (J), and one 5/16 in.

nylon locknut (K).

Attach Gage Plate to Spreader

MX40308

1. Hold assembled gage plate (A) over tow tube with flow control handle

up and link rod (B) facing hole (C) on the hopper control plate.

2. Rotate assembled gage plate (A) approximately 90° clockwise, and

insert formed end of the of the link rod (B) into the hole (C) on the hopper

control plate, as shown.

NOTE: Hardware for the next steps are found on the Hardware Skin

Pack (Z-1912).

MX40580

3. Rotate assembled gage plate (A) counter-clockwise until the handle is

oriented upward and the bottom of the gage plate is over the tow tube (D).

4. Attach the gage plate to the tow tube as shown by inserting two 5/16 x

H E