Instructions / Assembly

Assembly - 8

Assembly

NOTE: Hardware for the next step is found on the Hardware Skin

Pack (Z-1912).

MX40300

4. Install tow tube (F) onto support frame (D) with two 5/16 x 2-1/4 in. hex

bolts (G) and 5/16 in. hex nuts (H). Tighten nuts to 30 N•m (22 lb-ft), or two

complete turns after finger tight.

Install Transmission and Wheels

NOTE: Hardware for the next step is found on the Hardware Skin

Pack (Z-1912).

MX40403

1. Slide the fan driver (A) on the transmission assembly (B) shaft (with the

larger surface facing upward) and fan (C) onto the transmission assembly

(B) until both rest on the spring pin (D), as shown.

NOTE: Hardware for the next step is found on the Hardware Skin

Pack (Z-1912).

MX40301

2. Raise transmission into position by installing transmission fan shaft into

center hole of the control plates on the bottom of the hopper. Lower

transmission bracket (E) onto bolts (F).

3. Install axle (G) through support frame assembly (H) with offset hole

near center of axle to line up with hole in spreader transmission (I).

4. Secure the transmission bracket by installing two 5/16 in. flat washers

(J) and two 5/16 in. nylon locknuts (K). Tighten hardware finger tight.

IMPORTANT: Avoid damage! To avoid transmission damage, do

not adjust slot in transmission bracket forward or rearward. The

slot will self center as hardware is tightened.