Instructions / Assembly

Assembly - Thatcherator - 23

ASSEMBLY - THATCHERATOR

NOTE: If length (A) is 22.9 cm (9 in.) or more, wheel is

attached at top hole shown in wheel strap (B). Use

lower hole if length is less.

2. Install one 5/8 in. flat washer (C) onto 5/8 x 3 in. hex bolt

(D).

3. Slide wheel onto bolt so side with flat hub surface (not

rounded) is seated against washer and bolt head.

4. Install 5/8 in. flat washer (E) and 5/8 in. hex nut (F) onto

threaded end of bolt. Tighten nut enough so the wheel can

still spin freely.

5. Install wheel assembly to outside of wheel strap (B)

using top or bottom hole as required. Secure with

lockwasher (G) and 5/8 in. hex nut (H).

6. Hold a wrench on nut (F) and tighten nut (H) completely.

7. Repeat for other wheel assembly.

M92917A