Instructions / Assembly

Assembly - Plug Aerator - 25

ASSEMBLY - PLUG AERATOR

5. Install 5/16 x 1-1/2 in. cross hex bolt (I). Place chain

hook (H) around bolt and secure with 5/16 in. flat washer

and locknut (I).

6. Align tow bars and clevis. Tighten nuts (D) completely.

7. Tighten nylock nut (G) while holding chain hook forward

and centered between clevis halves.

Install Tow Bars to Tray Assembly

1. Stand plug tray assembly on its rear side.

NOTE: You may want to get a helper or use a hoist to

steady tow bars during alignment.

2. Align tow bars (A) to outside of brackets (B) and fasten

with two 5/16 x 1 in. hex bolts (C). Secure with 11/32 x 11/

16 x1/16 in. flat washers and nylock nuts (D) to the inside of

the bracket. Hand tighten only. Repeat for other side.

3. Hold tow bars all the way to top of slots and tighten

nylock nuts (D).

Install Lift Lever

1. Slide lift handle (A) into lift arm channel (B). Lift handle

offset goes to outside of lift arm.

2. Install 3/8 x 2 in. flat-top carriage bolt (C) with bolt head

to inside of lift arm. Slide spring (D) and 13/32 x 13/16 x 1/

16 in. flat washer (E) onto bolt.

NOTE: Make sure bolt head (C) is properly seated when

tightening locknut.

3. Install and tighten locknut (F) until one full thread is

exposed.

4. Install three transport pins (G) with threaded end to the

inside. Secure with 5/16 in. lockwashers and 5/16 in. hex

nuts on the inside. Tighten nuts completely.

CAUTION: Avoid injury! Plug spoons have

sharp edges.Wear gloves and handle with care.

M56882

M78707

CAUTION: Avoid injury! Plug Spoons have

sharp points. Wear gloves and handle with

care.

M78710

M78711