Instructions / Assembly

Assembly - Plug Aerator - 26

ASSEMBLY - PLUG AERATOR

5. Install vinyl handle grip (H) on lift handle.

Assemble Transport Wheels

1. Install 1/2 x 3 3/4 in. hex bolt (A) and 17/32 x 1/16 x 3/32

in. flat washer (B) on valve stem side of wheel hub.

2. Turn wheel over and install 17/32 x 1/16 x 3/32 in. flat

washer (C) and 1/2 in. hex nut (D).

3. Tighten nut (D) until washers (B) and (C) keep bearing

from turning on bolt without forcing bearings to be pressed

inward. After tightening, make sure the wheel can be

turned by hand with the bearing remaining stationary on

the bolt.

4. Repeat for other wheel assembly.

5. Install wheel assembly on lift arm (E). Then install 1/2 in.

lockwasher (F) and 1/2 in. hex nut (G). Hold wrench on nut

(D) and tighten nut (G) completely. This will ensure the

wheel hub remains properly adjusted.

6. Repeat for other wheel assembly.

M78700

M78713

M78714

M78715