Instructions / Assembly

Assembly - Spiker Aerator - 29

ASSEMBLY - SPIKER AERATOR

and 1/2 in. hex nut (D).

3. Tighten nut (D) until washers (B) and (C) keep bearing

from turning on bolt without forcing bearings to be pressed

inward. This causes wheel hub to rotate on bearings.

4. Install wheel assembly on lift arm (E), one on each side,

and secure with 1/2 in. lockwasher (F) and 1/2 in. hex nut

(G). Tighten nut securely so wheel hubs are free to turn on

bearings.

Install Lift Lever

1. Turn tray on its top and align lift lever (A), with offset to

outside, to right side of lift arm (B).

2. Fasten with 3/8 x 2 in. flat-top beveled carriage bolt (C),

head of bolt to the inside, and on outside spring (D), 3/8 in.

flat washer (E), and 3/8 in. oblong locknut (F).

NOTE: Be sure head of carriage bolt (C) is properly

seated in square hole of wheel assembly bracket

during tightening of locknut.

3. Tighten locknut (F) until one full thread is exposed.

4. Turn tray upright and install two 5/16 in. transport lock

pins (G), extending pin to the outside, and fasten with 5/16

in. lockwashers, and 5/16 in. hex nuts (H) to the inside.

Tighten nuts.

5. Install hand grip (I) on lift lever.

CAUTION: Avoid injury! Tines have extremely

sharp points. Wear gloves and handle with

care.

M79128

M79129

M79130

M79132