Instructions / Assembly

Assembly - Aerator-Spreader - 31

ASSEMBLY - AERATOR-SPREADER

2. Turn wheel over to install second 1/2 in. flat washer (C)

and 1/2 in. hex nut (D).

3. Tighten nut (D) until washers (B) and (C) keep bearing

from turning on bolt without forcing bearings to be pressed

inward. This causes wheel hub to rotate on bearings.

4. Install wheel assemblies to support brackets (E) and (F)

and fasten with 1/2 in. lockwasher (G) and 1/2 in. hex nut

(H).

5. Tighten nut securely so wheel hubs are free to turn on

bearings.

6. Set wheel assemblies aside.

Assemble Tow Bars

1. Align tow bars (A) as shown.

2. Align support strap (B) between tow bars and fasten

with two 5/16 x 1-1/2 in. hex bolts and nylock nuts (C).

Hand tighten only.

3. Assemble two clevis straps (D) to front of tow bars using

two 5/16 x 2-1/4 in. carriage bolts (E) and two locknuts (F).

Hand tighten only.

4. Slide clevis assembly forward until front carriage bolt is

within 6 mm (1/4 in.) from the end of tow bars.

5. Install hitch pin (G) in clevis and fasten with spring

locking pin (H) through chain loop.

6. Install 5/16 x 1-1/2 in. cross hex bolt (I). Place chain

hook (J) around bolt and secure with 5/16 in. flat washer

M78714

M93663

M93661

M56882