Instructions / Assembly

Assembly - Aerator-Spreader - 32

ASSEMBLY - AERATOR-SPREADER

and locknut (K).

7. Align tow bars and clevis. Tighten nuts (F) completely.

8. Tighten nylock nut (K) while holding chain hook forward

and centered between clevis halves.

9. Tighten tow bar nylock nuts (C).

Install Tow Bars, Wheel Assembly, and Lift

Lever to Hopper

1. Align four tow bar holes with four hopper side holes.

2. Fasten tow bar to hopper with three 5/16 x 3/4 in. hex

bolts, bolt heads to the inside, and nylock nuts (A). Hand

tighten only.

3. Install three transport lock pins (B) into lift plate (C) as

shown and fasten with three 5/16 in. lockwashers and hex

nuts (D).

4. Install left wheel assembly (E) with long shaft through

large holes (F) of tow bar.

5. Install lift plate assembly (C) onto end of long shaft.

6. Align small hole of lift plate with tow bar and hopper

small holes.

7. Fasten with 5/16 x 1-1/4 in. hex bolt and nylock nut (G).

8. Hold tow bar so top edge of tow bar is parallel with top

edge of hopper.

9. Tighten three nylock nuts (A) and last installed nylock

nut (G).

M93662

M93640

M79139

M93641

M93642