Instructions / Assembly

Assembly - Aerator-Spreader - 33

ASSEMBLY - AERATOR-SPREADER

10.Install 3/8 x 2 in. special bolt (H), head of bolt to the

inside, into right wheel assembly bracket (I).

11.Install right wheel assembly (I) on to end of long shaft

and fasten with 5/16 x 1-1/2 in. hex bolt and nylock nut (J).

12.Install lift lever (K), with offset to the outside, onto

special bolt (H) and fasten with spring (L), 3/8 in. flat

washer (M), and 3/8 in. locknut (N).

NOTE: Be sure head of special bolt (H) is properly

seated in square hole of wheel assembly bracket

during tightening of locknut.

13.Tighten locknut (N) until one full thread is exposed.

14.Slide vinyl handle grip (O) over end of lift lever.

Install Hopper Flow Control Lever

1. Stand hopper assembly on its back.

2. Remove 5/16 x 1-1/2 in. hex bolt, two large flat washers,

and locknut (A) from hopper.

3. Install “L”-shaped end (B) of flow control lever into slot of

calibration plate (C).

4. Install one end of shutter link (D) into end of flow control

lever.

M93643

M93644

M79131

CAUTION: Avoid injury! Aerator Tines are

extremely sharp. Wear gloves and handle with

care.

M93646

M93647

M93648