Instructions / Assembly

Assembly - Aerator-Spreader - 34

ASSEMBLY - AERATOR-SPREADER

5. Slide lever down between hopper and spike assembly

and install other end of shutter link (D) into shutter arm (E).

6. Slide lever up to align pivot hole with hopper hole and

fasten with 5/16 x 1-1/2 in. hex bolt and large washer,

(inside-out), and second large washer and locknut (A),

(from the outside).

7. Tighten locknut until lever has sufficient drag to hold its

position when released.

8. Return hopper assembly to the upright position.

9. Move lever into closed position and lock it with wing nut

lock assembly (F).

Install Weight Tray

1. Install last transport lock pin (A) into center hole of rear

hopper lip and fasten with 5/16 in. lockwasher (B) and hex

nut (C).

2. Install weight tray (D) over pin (A) and hopper lips as

shown.

M93649

M93651

M93657

M93645

M93656