Instructions / Assembly

Assembly - Lawn Roller - 36

ASSEMBLY - LAWN ROLLER

3. Slide one end of the scraper frame bar on one end of

roller assembly and then spring the other end of scraper

frame bar open and slide it over the opposite end of roller

axle as shown.

4. Install another 5/8 in. flat washer (D) over each end of

axle and secure with a 5/8 in. snap ring (E).

Install Frame Extension Bars

1. Attach short end of each frame extension bar (A) to

scraper frame bar (B) and fasten with two 5/16 x 1 in. hex

bolts (C) and two 5/16-18 in. nylock nuts (D) on each side.

Frame extension bars will meet at center. Hand tighten

only.

2. Position spacer (E) between frame extension bars (A),

using rear set of holes, and secure with a 5/16 x 1-1/2 in.

hex bolt (F) and 5/16 in. nylock nut (G). Hand tighten only.

3. Assemble two clevis straps (H) to front of tow bars using

two 5/16 x 2-1/4 in. carriage bolts (I) and two locknuts (J).

Hand tighten only.

4. Slide clevis assembly forward until front carriage bolt is

within 6 mm (1/4 in.) from the end of tow bars.

5. Install hitch pin (K) in clevis and fasten with spring

locking pin (L) through chain loop.

6. Install 5/16 x 1-1/2 in. cross hex bolt (M). Place chain

hook (N) around bolt and secure with 5/16 in. flat washer

and locknut (O).

7. Align tow bars and clevis. Tighten nuts (J) completely.

8. Tighten nylock nut (M) while holding chain hook forward

and centered between clevis halves.

9. Tighten all bolts completely.

M56874

M56875

M56876

M56882