Use and Care Manual

Assembly - 4

ASSEMBLY

Assemble Cart

When assembling cart, do the following

• Do not discard cardboard bed divider, it can be used as a template for

making dividers for the cart.

• Place pieces of carton under cart box to help avoid scratching finish.

• Put all bolt heads to the inside of the cart box.

Install Axle Support

MX36393

1. Place axle support (A) on bottom of cart.

2. Install eight 5/16 x 1 in. slotted head screws (B) and eight 5/16 in. flat

washers (C), from inside cart box through axle support. Place eight 5/16

in. lockwashers (D) and eight 5/16 in. nuts (E) on screws.

3. Tighten nuts.

Install Lock Bracket

NOTE: Make sure notch on lock bracket is facing to the front of the

cart.

MX36394

1. Place lock bracket (A) on cart.

2. Install two 5/16 x 1 in. slotted head screws (B) and two 5/16 in. flat

washers (C) through cart box (from inside cart box) and lock bracket.

3. Secure with two 5/16 in. lockwashers (D) and two 5/16 in. nuts (E).

4. Tighten nuts.

Assemble Cart Lock Bar

MX36395

Picture Note: Bottom of drawbar shown

1. Place cart lock bar (A) through slot in drawbar (B) with notch (C) in lock

bar to rear of cart.

NOTE: Locknuts with attached star washers should be installed on

each side of the cart lock bar so it is centered.

Pull up on lock bar while installing bolt. This will help to align the

bolt with the hole on the other side of the drawbar.

MX36396

2. Install one 3/8 x 3-3/4 in. bolt (D) and two 3/8 in. nuts with attached star

washers (E) through drawbar and lock bar.

3. Tighten nuts securely

4. Secure bolt with 3/8 in. locknut (F) so lock bar moves forward and

backward freely.

5. Hook one end of spring (G) in hole (H) in lock bar (A); stretch spring to

hook other end in cart drawbar hole (I).

E F