Use and Care Manual

Installing - 5

INSTALLING

Install Clevis

MX36397

1. Place clevis pin (A) on cart drawbar. Secure with 1/8 in. spring locking

pin (B).

2. Install two 5/16 x 1 in. slotted head screws (C) through clevis and cart

drawbar.

3. Fasten with two 5/16 in. lockwashers (D) and two 5/16 in. nuts (E).

4. Tighten nuts.

Install Cart Drawbar and Wheels

MX36398

1. Place drawbar (A) on axle support (B) and lock bracket (C).

NOTE: A light coating of grease or oil on axle will aid in inserting the

axle through the axle support.

2. Slide axle (D) through axle support and drawbar.

3. Slide one 3/4 in. bushing (E) on both axle ends.

NOTE: Put a small amount of grease on each end of axle, before

installing wheels. This will make installing wheels on axle easier.

4. Put one wheel (F) (valve stem to the outside) on axle.

5. Put second 3/4 in. bushing (E) and one retaining ring (G) on axle.

6. Repeat steps for other wheel.

7. Inflate tires to correct tire pressure.

8. Grease wheel bearings with John Deere multipurpose grease or an

equivalent.

Installing

Installing Cart

MX36820

1. Lock cart lock bar (A) in place.

2. Park machine safely. (See Parking Safely in the Safety section.)

3. Align cart drawbar with machine drawbar.

4. Install clevis pin (B) through cart drawbar and machine drawbar. Secure

clevis pin with 1/8 in. spring locking pin.

Removing

Removing Cart

NOTE: Refer to illustrations in the Installing Section, earlier in this

manual.

1. Park machine safely. (See Parking Safely in the Safety section.)

2. Unload cart.

c CAUTION: Avoid injury! Before installing cart, make sure

dump lever is locked in place.

c CAUTION: Avoid injury! Before installing cart, make sure

transport latch is facing toward cart dump lever and dump lever is

locked in place.