JLBICH605 Ceramic glass hob Instruction manual
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
• There is the risk of burns from the appliance if used carelessly. • Cables from electrical appliances must not touch the hot surface of the appliance or hot cookware. • Overheated fat and oil can ignite quickly. Warning! Fire hazard! • Switch the cooking zones off after each use. • The ceramic glass can be damaged by objects falling onto it. • The edge of the ceramic glass can be damaged by being knocked by the cookware.
Contents For the User For the Installer Important safety information 2 Installation Installation Child safety Use Maintenance and cleaning Service 2 2 2 3 3 Description of the appliance 5 5 Cooking surface layout The control panel Touch control sensor fields Switching the appliance on and off Technical data Electrical connection 5 6 6 Electrical requirements 15 15 Building in 16 Guide to use the instruction manual When the hob is first installed 8 14 14 Hints and tips on cooking and frying
Description of the appliance Cooking surface layout 1 145 2 mm 180 145 m 0m 21 5 4 1. Single cooking zone 1200W 2. Single cooking zone 1800W 3. Single cooking zone 1200W mm mm 3 4. Control panel 5. Single cooking zone 2300W The control panel 1 2 3 1. On/Off 2. Cooking zones and heat setting selection 3.
confirmed by displays. Touch the sensor fields from above, without covering other sensor fields. Touch control sensor fields The appliance is operated using the Touch Control sensor fields.
Selecting the heat setting Control panel Indicator To increase Touch to To decrease Touch to To switch off Touch and at the same time Using the child safety device The child safety device can only be activated immediately after the appliance has been switched on. The child safety device prevents unintentional use of the appliance. Switching on the child safety device Step Control panel 1. Switch on the appliance. (Do not set a heat setting.) 2.
Step 1. 2. Control panel Display/Signal Switch the appliance on Touch of both the cooking zones at the front simultaneously for 4 seconds. Until the appliance is next switched off, it can used as normal. After switching off the appliance, the child safety device is active again. After overriding the child safety device, a heat setting or a function must be set within approx. 10 seconds, otherwise the appliance automatically switches itself off.
Hints and tips on cooking and frying Information on acrylamides According to the latest scientific knowledge, intensive browning of food, especially in products containing starch, can constitute a health risk due to acrylamides. Therefore we recommend cooking at the lowest possible temperatures and not browning foods too much. Always place cookware on the cooking zone before it is switched on. Cookware If possible, always place lids on the pans.
Cooking table This table is intended as a guide only. It may be necessary to increase or decrease the temperature to suit your individual requirements. Only experience will enable you to determine the correct setting for your personal requirements.
Cleaning the hob 2. Rub the appliance dry using a clean cloth. Warning! Risk of burns from residual heat. Removing deposits 1. Place a scraper on the glass ceramic surface at an angle. 2. Remove residues by sliding the blade over the surface. 3. Wipe the appliance with a damp cloth and a little washing up liquid. 4. Rub the appliance dry using a clean cloth. Warning! Sharp objects and abrasive cleaning materials will damage the appliance. Clean with water and washing up liquid.
Something is not working Problem Possible cause Remedy The cooking zones will not More than 10 seconds have passed Switch the appliance on again. switch on or are not since the appliance was switched on functioning. The child safety device is switched on Deactivate the child safety device (See the section “Child safety device”) Several sensor fields were touched Only touch one sensor field at the same time Automatic switch off has been triggered Remove any objects (pan, cloths, etc.
If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Warning! Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. Repairs - after sales service PNC: S.N.: Your hob is covered by a 3 year parts and labour guarantee (see separate details given at point of sale).
Installation Technical data Appliance dimensions Width 590 mm Depth 520 mm Height 47 mm Worktop cut-out dimensions Width 560 mm Depth 490 mm Cooking rings Position Diameter Power Front left 210 mm 2300W Rear left 145 mm 1200W Rear right 180 mm 1800W Front right 145 mm 1200W Connection voltage 230 V ~ 50Hz Maximum connected load power 6,5 kW • 93/68 (General Directives); • 89/336 (Electromagnetical Compatibility Directive) and subsequent modifications This appliance complies wit
Electrical connection It is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current rules. Warning! This hob must be earthed. Electrical requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local Electricity Board regulations.
Building in Warning! The hob must be installed according to the instructions supplied by qualified and competent personnel to the relevant National Standards. Building in • The dimensions of the cut-out section and recess required must be as shown in the relevant diagrams. • Proper arrangements must be made of a continuous supply of air to the hob to prevent overheating. • Clean the worktop in the area of the cutout section.
John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.
