User manual

Remove all accessories and removable shelf
supports.
The walls and the top of the cavity are catalytic-
coated. They absorb fat and food particles at
high temperature without smell.
To support this self-cleaning process heat the
appliance without any food regularly.
Spots or discolouration of the
catalytic surface have no effect on
catalytic properties.
1. Touch again and again until the display
shows "Cata" and the duration of the cleaning
procedure (1 hour).
You cannot set the Duration, but you can use
the End function to delay the start of the
cleaning procedure.
An acoustic signal sounds after the time ends.
The appliance deactivates.
2. Touch a sensor field or open the oven door to
stop the acoustic signal.
3. Clean the bottom of the appliance with a soft
and moist sponge.
Removing and installing the
door
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
Warning! Be careful when you
remove the door from the
appliance. The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on the two
door hinges.
A
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door with one hand on each side and
pull it away from the appliance at an upwards
angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to prevent
scratches.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
2
B
Caution! Rough handling of
the glass, especially around
the edges of the front panel,
can cause the glass to break.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
Built-Under Double Oven User Manual
30