User manual

Something not working
The appliance does not start or it stops during
operation.
Certain problems are due to the lack of simple
maintenance or oversights, which can be solved
with the help of the indications described in the
table, without calling out an engineer.
With some malfunctions, the display
shows an alarm code:
•
- The appliance does not fill with water
•
- The appliance does not drain the water
•
- The anti-flood device is on.
Malfunction Possible cause Possible solution
The appliance does not fill with
water.
The water tap is blocked or there
is limescale on it.
Clean the water tap.
The water pressure is too low. Contact your local Water
Authority.
The water tap is closed. Open the water tap.
The filter in the water inlet hose is
blocked.
Clean the filter.
The connection of the water inlet
hose is not correct.
Make sure that the connection is
correct.
The water inlet hose is damaged. Make sure that the water inlet hose
has no damages.
The appliance does not drain the
water.
There is a blockage in the sink
spigot.
Clean the sink spigot.
The connection of the water drain
hose is not correct.
Make sure that the connection is
correct.
The water drain hose is damaged. Make sure that the water drain
hose has no damages.
The anti-flood device is on. Close the water tap and contact
our extended warranty
administrators. Refer to 'Repairs -
after sales service'.
The start of the washing
programme does not occur.
The appliance door is open. Close the appliance door.
The mains plug is not connected in
the mains socket.
Connect the mains plug.
The fuse in the fuse box is
damaged.
Replace the fuse.
26 Dishwasher user manual