JLBIFF1803 Fridge-Freezer Instruction manual
Safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
• The appliance is intended for keeping foodstuff and/or beverages in a normal household as explained in this instruction booklet. • Do not use a mechanical device or any artificial means to speed up the thawing process. • Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer. • Do not damage the refrigerant circuit.
• Please refer to the correct positioning and location instructions that can be found in the Installation section of this user guide. • The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is accessible after the installation of the appliance. • Appliance's manufacturers storage recommendations should be strictly adhered to. Refer to relevant instructions.
Contents For the user For the installer Safety information 2 Technical data 16 Control panel 6 6 6 6 6 6 Installation Location Positioning Electrical Connection Door reversibility Installing the appliance 16 16 17 17 18 18 Switching on Switching off Temperature regulation Quick Freeze function Fan function Operation Switching on Switching off Temperature regulation First use Cleaning the interior Daily use Freezing fresh food Storage of frozen food Thawing Cold accumulators Ice-cube production
Control panel 1 1 2 3 4 5 6 2 3 4 5 6 However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance. On/Off Pilot Light Temperature Regulator Quick Freeze light Quick Freeze switch Fan light Fan switch Switching on Insert the plug into the wall socket. Turn the Temperature Regulator clockwise to a medium setting.
Important! If the function is activated automatically the Fan indicator is not shown (refer to "Daily use"). The activation of the Fan function increases the energy consumption. Operation Switching on However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance. Turn the Temperature regulator clockwise to a medium setting.
Important! Do not use detergents or abrasive powders, as these will damage the finish. Daily use Freezing fresh food Important! In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer than the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling).
Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Bottle rack Important! Place the bottles (with the opening facing front) in the pre-positioned shelf. Do not move the glass shelf above the vegetable drawer to ensure correct air circulation Important! If the shelf is positioned horizontally, place only closed bottles. This bottle holder shelf can be tilted in order to store previously opened bottles.
Fan The refrigerator compartment is equipped with a fan that allows for rapid cooling of foods and more uniform temperature in the compartment. This fan activates by itself when needed, for example for a quick temperature recovering after door opening or when the ambient temperature is high. Allows you to switch on the fan manually when needed (refer to " Fan Function"). Important! The Fan stops when the door is open and restarts immediately after the door closing.
• wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; • do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; • lean foods store better and longer than fatty ones; salt reduces the storage life of food; • it is advisable to show the use by date on each individual pack to enable you to keep tab of the storage time.
Care and Cleaning casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorised technicians. Defrosting of the freezer The freezer compartment of this model, on the other hand, is a "no frost" type.
provided, which you will find already inserted into the drain hole. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from electricity supply • remove all food • defrost2) and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.
Problem Possible cause Solution The lamp does not work. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The temperature is not set correctly. Set a higher temperature. The door is not closed correctly. Refer to "Closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high. Let the product temperature decrease to room temperature before storage.
1. Disconnect the mains plug from the mains socket. 2. Press on the rear hook and at the same time slide the lamp cover in the direction of the arrow. 3. Replace the lamp with one of the same power and specifically designed for household appliances. (the maximum power is shown on the light lamp cover) 4. Install the lamp cover by sliding it into its original position. 5. Connect the mains plug to the mains socket. 6. Open the door. Make sure that the lamp comes on. Closing the door 1.
Technical data Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 21 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
Positioning GREEN & YELLOW 13 AMP. FUSE Warning! If you are discarding an old appliance that has a lock or catch on the door, you must ensure that it is made unusable to prevent young children being trapped inside. Important! The appliance should have the plug accessible after installation.
The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. 1 Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. 2 Door reversibility 1 The door of the appliance opens to the right. If you want to open the door to the left, do these steps before you install the appliance: 1.
1. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. 2 1 X X 4. 2. Drill the hinge cover 1, as shown in figure. Apply the covers 1 and 2 (in the accessories bag) in to the middle hinge. 1 3. 2 Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture.
4mm 44 mm 5. 7. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. Attach the appliance to the niche with 4 screws. D E I E 8. 6. C Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. 20 B If the appliance must connect laterally to the kitchen furniture door: a) Slacken the screws in fixing brackets (H).
ca. 50 mm 90o 21 mm H ca. 50 mm H 9. 90o 21 mm Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha 11. Push the part (Hc) on the part (Ha). Hb Ha Hc Hc Hd 10. Install the part (Ha) on the inner side of the kitchen furniture. 12. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes.
8 mm Ha Hb Hb 13. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K) 15. Press the part (Hd) on the part (Hb). 8 mm Hb Ha Hd Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. K 14. Align the kitchen furniture door and the appliance door by adjusting the part Hb.
Your appliance is covered by a 3 year parts and labour guarantee (see separate details given at point of sale). Please retain your purchase receipt safely for the service engineer to verify the purchase details. When you contact your local repair agent you will need to give the following details: 1. Your name, address and post code. 2. Your telephone number. 3. Clear and concise details of fault. 4. The purchase date (found on your receipt). 5.
John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.
