User manual

ManualsBrandsJohn Lewis ManualsDomestic AppliancesJLBIGGH703

Electrical ConnectionsElectrical Connections

Electrical Connections

THIS HOB MUST BE EARTHIS HOB MUST BE EAR

THIS HOB MUST BE EAR

THEDTHED

THED

Any electrical work required to install this hob should

be carried out by a qualified electrician or competent

person, in accordance with the current regulations.

Electrical RequirementsElectrical Requirements

Electrical Requirements

Any permanent electrical installation must comply with the

latest I.E.E. Regulations and local Electricity Board regulations.

For your own safety this should be undertaken by a qualified

electrician, e.g. your local Electricity Board, or a contractor

who is on the roll of the National Inspection Council for

Electrical Installation Contracting (NICEIC).

Electrical Connections

This hob is designed to be connected to a 230 V 50 Hz AC

electrical supply.

Before switching on, make sure the electricity supply voltage

is the same as that indicated on the hob rating plate. The

rating plate is located on the bottom of the hob. A copy is

attached on the back cover of this book.

The hob is supplied with a 3 core flexible supply cables.

This has to be provided with a proper plug, able to support

the load marked on the identification plate. To connect the

plug to the cable, follow the recommendation given in diagram

aside. The plug has to be fitted in a proper socket.

In the event of having to change the fuse, a 3amp ASTA

approved (BS 1362) fuse must be used.

Should the plug need to be replaced for any reason, the

wires in the mains lead are coloured in accordance with the

following code:

Green and Yellow - Earth

Blue - Neutral

Brown - Live

— Connect the green and yellow (earth) wire to the

terminal in the plug which is marked with the

letter 'E' or the earth symbol or coloured green

and yellow.

— Connect the blue (neutral) wire to the terminal

in the plug which is marked with the letter 'N' or

coloured black.

— Connect the brown (live) wire to the terminal in

the plug which is marked with the letter 'L' or

coloured red.

Upon completion there must be no cut, or stray strands of

wire present and the cable clamp must be secure over the

outer sheath.

A cut off plug inserted into a 13 amp socketA cut off plug inserted into a 13 amp socket

A cut off plug inserted into a 13 amp socket

is a serious safety (shock) hazard. Ensureis a serious safety (shock) hazard. Ensure

is a serious safety (shock) hazard. Ensure

thatthat

that

the cut off plug is disposed of safthe cut off plug is disposed of saf

the cut off plug is disposed of saf

elel