User manual

ermanent Connectionermanent Connection

ermanent Connection

In the case of a permanent connection, it is necessary that

you install a double pole switch between the hob and the

electricity supply (mains), with a minimum gap of 3 mm

between the switch contacts and of a type suitable for the

required load in compliance with the current electric

regulations.

The switch must not break the yellow and green earth cable

at any point.

Ensure that the hob supply cable does notEnsure that the hob supply cable does not

Ensure that the hob supply cable does not

come into contact with surfaces withcome into contact with surfaces with

come into contact with surfaces with

temperatures higher than 50 deg. C.temperatures higher than 50 deg. C.

temperatures higher than 50 deg. C.

Min. size Cable/flexMin. size Cable/flex

Min. size Cable/flex

Cable / flex typeCable / flex type

Cable / flex type

FuseFuse

Fuse

0.75 mm

H05 V2V2-F (T90) 3 A

Supply cable replacementSupply cable replacement

Supply cable replacement

The cable used to connect the hob to the electrical supply

must comply to the specifications given below.

NeutralNeutral

Neutral

Earth (yellow/green)Earth (yellow/green)

Earth (yellow/green)

The manufacturer declines any liability should theseThe manufacturer declines any liability should these

The manufacturer declines any liability should these

safety measures not be observed.safety measures not be observed.

safety measures not be observed.