JLBIUCL 01 built-in refrigerator Instruction manual
Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
Environmental Information • When disposing of your appliance, use an authorised disposal site. • Remove the plug and ensure that any locks or catches are removed, to prevent young children being trapped inside. • The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Contents For the Installer For the User Important Safety Information 2 Installation 6 Description of the appliance 5 Technical Specification 6 Operation 13 Electrical Connection 6 Before using 13 Positioning 7 Start your appliance 13 Door Reversal 8 Temperature control 13 Fresh food refrigeration 13 Building In 9 Normal operating sounds 13 Movable shelves 14 Positioning the door shelves 14 Hints and Tips 15 Maintenance and Cleaning 16 Internal cleaning 16 When the appl
Description of the Appliance 1 Dairy compartments 2 Movable storage shelf 3 Bottle storage shelf 4 Interior light 5 Storage shelves 6 Salad crispers 4 1 5 2 3 6 1 5
Installation It is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Care must be taken to ensure that the appliance does not stand on the electrical supply cable.
Important Warning IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens.
Door Reversal To reverse the opening direction of the door, proceed as shown in the figures: 6 6 4 1 7 8 5 2 1 6 3 2 6 Warning After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
Building In Before carrying out any work, remove the plug from the power socket. Grid preparation Building in the appliance under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). 60 0 A 5 min50 . 600 B DO013 Installation kit DO002/2 1xB 2xC Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure).
2. Push the appliance into place.The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. 3. To adjust the height proceed as follows: - Loosen or tighten the two front feet. - The rear feet are adjusted by turning the screw in the front kick plate to the left or right. 4. The joint cover (B) is to be assembled after having installed the appliance in the recess. b) 1 596 B 5 55 x ma + - - 4 + E 3 5.
F I 27 ,5 cm 55 27 ,5 cm cm 10 7 1 2 45° a b 3 C click 11 click c 8 1 Upper part of kitchen furniture panel Möbeltür Innenseite a I = = = 2 10 = c 9 12 b 11
Fitting the plinth m 8m I F K G 13 Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments.The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm.
OPERATION Before using Remove all securing tapes.Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Important Start your appliance During prolonged periods of abnormally hot weather, if the thermostat is set on too high a number, the cooling system may operate continuously and the fridge cooling plate may not defrost.Turning the knob to a lower number will cause the automatic defrosting to resume.
Movable shelves The walls of the refrigerator have runners so that the shelves can be positioned as desired . For better use of space, the front half-shelves can lie over the rear ones. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height.To make these adjustments proceed as follows: Remove the top door shelf by pulling them in the direction of the arrows, then gradually slide the shelf sideways until it comes off.
Hints and Tips Food Storage Energy Saving Advice • To obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder compartment. • Do not install the cabinet close to sources of heat, i.e. boiler or radiator. • Keep the time between buying chilled food and placing it in your fridge as short as possible. • Do not push food together too much, try to allow air to circulate around each item. • Do not store food uncovered.
Maintenance and Cleaning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES,TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG ODOUR.
Something not working Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: SYMPTOM 4 No power to the appliance SOLUTION Check there is power at the socket. Check there is not a power cut by checking the household lights. 4 The light does not come on Check the fuse has not blown.
Repairs - After Sales Service If your appliance is not performing satisfactorily; consult the fault finding guide within this instruction book (Something not working). In the event of a fault occurring which you cannot resolve yourself from advice given within this instruction manual your first step is to contact our extended warranty administrators on 0870 0107887 who will give you details for your local Service Force Repair Agent. When contacting the repair agent, please quote the model (Mod.
John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.
