JLDWW 1206 Dishwasher Instruction manual
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
• The water in your dishwasher is not for drinking. Detergent residues may still be present in your machine. • Ensure that the door of the dishwasher is always closed when it is not being loaded or unloaded. In this way you will avoid anybody tripping over the open door and hurting themselves. • Do not sit or stand on the open door. • Keep all detergents in a safe place out of children’s reach. • Keep children well away from the dishwasher when the door is open.
• 45°-70° Auto Wash Programme: This machine is fitted with a turbidity sensor which intelligently adjusts the temperature and rinsing cycles during the wash programme, depending on the degree of soiling on the dishes. This helps to reduce energy and water consumption on lightly soiled loads. • Half load: This option is useful and economical when baskets are not fully loaded. The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
Contents For the user For the installer Important safety information 2 Technical data 27 Description of the appliance 27 27 27 28 6 Installation Menu options 7 8 Washing programmes Unpacking Fitting under a counter Levelling 9 Control panel Water connections Water inlet connection When the dishwasher is first installed 10 Water drain connection The water softener 10 Electrical connection 28 28 29 31 Filling with dishwasher salt Filling with rinse aid Adjusting the rinse aid dosage 12 12 13
Description of the appliance 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Worktop Upper basket Water hardness dial Salt container Detergent dispenser Rinse aid dispenser Rating plate Filters Lower spray arm Upper spray arm This dishwasher has an internal light that turns on when the door opens, and off when it closes. Internal light is equipped with led lamp CLASS 1 in accordance with EN 60825-1: 1994 + A1: 2002 + A2: 2001. In case this light has to be replaced, please, contact your local repair agent.
Control panel 6 1. 2. 3. 4. 5. 6. When using this option we recommend that you reduce the dose of detergent that is normally used for a complete load. Press the half load button to activate the option: • the half load option is NOT available with ''45°-70° Auto'' programme; the half load indicator light will not illuminate when the half load button is pressed and the message NOT SELECTABLE will appear on the display.
Menu options The appliance will return to the programme menu if an option is not selected within a few seconds. Setting an option is possible ONLY with the appliance in setting mode. The message CHOOSE PROGRAMME on the display indicates that the appliance is in setting mode. It will NOT be possible to enter the menu options when: • A washing programme and a delay start have already been set or are in progress. Cancel the programme and delay start to return to setting mode.
Washing programmes Programme 70° INTENSIVE Degree of soil Heavy soil 45°-70° AUTO1) Any Type of load Programme description Prewash Crockery, Main wash cutlery, pots and 2 intermediate rinses pans Final rinse Drying Prewash Crockery, Main wash cutlery, pots and 1 or 2 intermediate rinses pans Final rinse Drying 50° ECONOMY2) Normal soil Crockery and cutlery Prewash Main wash 1 intermediate rinse Final rinse Drying 60° QUICK3) Normal or light soil Crockery and cutlery Main wash Final rinse GLA
Half load option available with programme: YES (no impact on washing programme) RINSE HOLD Consumption values Programme Programme duration (in minutes) Water consumption (in litres) 1) Energy consumption (in kWh) 70° INTENSIVE - 1,8 - 2,0 23 - 25 45°-70° AUTO - 1,1 - 1,7 12 - 23 - 1,0 - 1,1 12 - 13 60° QUICK - 0,9 9 GLASS - 0,8 - 0,9 14 - 15 RINSE HOLD - 0,1 4 50° ECONOMY2) 1) The display shows the programme duration. 2) Test programme for test institutes.
mmol/l (millimol per litre - international unit for the hardness of water). The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area. a detrimental or adverse effect on the operation of the appliance. The higher the content of these minerals and salts, the harder your water is.
5. Replace the cap tightly turning it clockwise until it stops with a click. Filling with dishwasher salt Do not worry if water overflows from the unit when filling with salt, this is quite normal. Warning! Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes.
Adjusting the rinse aid dosage According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1= minimum dosage, position 6= maximum dosage). 2. Add the rinse aid in the container. The maximum level for filling is indicated by "max". The dose is factory set in position 4. Increase the dose if there are drops of water or lime spots on the dishes after washing.
Daily use • When loading the dishes and cutlery, please note: – Dishes and cutlery must not impede the rotation of the spray arms. – Load hollow items such as cups, glasses, pans, etc. with the opening downwards so that water cannot collect in the container or a deep base. – Dishes and items of cutlery must not lie inside one another or cover each other. – To avoid damage to glasses, they must not touch. – Lay small objects in the cutlery basket.
The lower basket The lower basket is designed to take saucepans, lids, plates, salad bowls, cutlery, etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the spray arms can turn freely. The cutlery basket Warning! Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives.
If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together. For best results we recommend you use the cutlery grids. If the size and dimensions of the cutlery do not allow the use of the grids, they can be easily hidden or removed. Glasses with long stems can be placed upside down in the cup racks. For taller items, the cup racks can be folded upwards.
For glasses with long stems (according to the size and dimensions), set the glass holder to the left or right position. Maximum height of the dishes in the lower basket With upper basket raised 31 cm With upper basket lowered 27 cm To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. The central rows of prongs can be easily lowered to improve loading flexibility.
Warning! After loading your machine always close the door, as an open door can be a hazard. Use of detergent Only use detergents specifically designed for use in dishwashers. Please observe the manufacturer’s dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent 3.
Detergent tablets Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Multi tab function This appliance is equipped with the Multi tab function, that allows the use of combi detergent tablets.
If you decide to revert back to the use of individual detergents we advise that you: 1. Deactivate the Multi tab function. 2. Fill up the dispensers for salt and rinse aid again. 3. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. 4. Adjust the water hardness setting according to the hardness of the water in your area. 5. Adjust the rinse aid dosage. If the drying results are not satisfactory we suggest that you: 1.
The washing programme or the delay start has been cancelled. • If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. The countdown will decrease in steps of 1 hour. Opening the door will interrupt the countdown. Close the door; the countdown will continue from the point at which it was interrupted. Once the delay start has elapsed the programme will start automatically.
Unloading the dishwasher • Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. • Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. • Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
flat filter does not protrude above the base of the washing compartment. NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results and will result in damage to the appliance. NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove the debris with a cocktail stick. 4. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). 5.
1. Unplug it. 2. Turn the water tap off. 3. Remove the water inlet and discharge hoses. 4. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house, etc...
Fault code and malfunction • intermittent audible signal is active1) • appears in the digital display • message SERVICE NUMBER displayed Anti-flood device is activated Possible cause and solution • Close the water tap and contact our extended warranty administrators, refer to Repairs-After Sales Service on the following pages. 1) Audible signals not active if option sound volume has been deactivated.
The wash results are not satisfactory The dishes are wet and dull • Rinse aid was not used. • The rinse aid dispenser is empty. There are streaks, milky spots or a • Decrease rinse aid dosage. bluish coating on glasses and dishes Water drops have dried onto glasses and dishes • Increase rinse aid dosage. • The detergent may be the cause. Contact the detergent manufacturer’s consumer care line.
Technical data Dimensions Width Height Depth 60 cm 85 cm 61 cm Electrical connection - Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door. Water supply pressure Minimum Maximum 0,05 MPa (0,5 bar) 0,8 MPa (8 bar) Capacity 12 place settings Installation Fitting under a counter Warning! It is dangerous to alter the specifications or attempt to modify this product in any way. This appliance is heavy.
Remove the machine’s worktop by unscrewing the two rear retaining screws (1), pull the worktop from the back of the machine (2) and slide out the front slots, lifting the worktop (3). Insert the machine after adjusting the levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. During all operations that involve accessibility to internal components the dishwasher has to be unplugged.
The water inlet hose must not be kinked, crushed, or entangled when it is being connected. The appliance features inlet and drain hoses which can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. (Attention! NOT all models of dishwashers have inlet and drain hoses provided with a locknut.
When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot. Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher.
Electrical connection Warning! Safety standards require the appliance to be earthed. Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate. Always plug the mains plug into a correctly installed shockproof socket. Multi-way plugs, connectors and extension cables must not be used.
4. The purchase date (found on your receipt). 5. The model and serial number of the appliance (found on the rating plate). So that you always have these numbers at hand, we recommend that you make a note of them here: Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . S.No. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.