User manual
6
Fitting the wall brackets
• Draw a vertical line on the supporting wall up to the
ceiling, or as high as practical, at the centre of the
area in which the hood will be installed.
• Draw a horizontal line at 650 mm above the hob.
• Place bracket 7.2.1 on the wall as shown about
1-2 mm from the ceiling or upper limit aligning the
centre (notch) with the vertical reference line.
• Mark the wall at the centres of the holes in the
bracket.
• Place bracket 7.2.1 on the wall as shown at X mm
below the rst bracket (X = height of the upper
chimney section supplied), aligning the centre (notch)
with the vertical line.
• Mark the wall at the centres of the holes in the
bracket.
• Mark a reference point as indicated at 116 mm from
the vertical reference line and 306 mm above the
horizontal reference line.
• Repeat this operation on the other side.
• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the lower bracket 7.2.1 using the 12a screws
(4,2 x 44,4) supplied.
• Fix the upper bracket 7.2.1 using the 2 screws 12a
(4,2 x 44,4) supplied.
• Fix the Hood Body Fixing Brackets 7.1 using the 2
screws 12a (4,2 x 44,4) and Washers 22 supplied,
checking levelling.
Note: If the hood is to be installed onto a hollow
construction or plaster or partition board wall
then special xing screws will be required (not
supplied).
Fitting the canopy hood
• Hook the hood canopy onto the bracket 7.1.
• Tighten denitly the Hood with 2 screw 12t.
Hook both sides of the hood at the same
time.
Installing the cooker hood
Vt
7.1