User manual

5. Remove the polystyrene protection from the

bottom. Put the appliance back into an upright

position.

6. Remove the power supply cable and the drain hose

from the hose holders.

It is possible to see water flowing from the drain hose.

This is because the washing machine has been tested at

the factory.

7. Remove the three transit bolts and pull out the

plastic spacers.

8. Put the plastic caps, that you find in the user

manual bag, in the holes.

We recommend that you keep the

packaging and the transit bolts for

any transport of the appliance.

Information for installation

Positioning and levelling

Adjust the appliance correctly to prevent

vibration, noise and movement of the appliance

when it operates.

1. Install the appliance on a flat hard floor. The

appliance must be levelled and stable. Make sure

that the appliance does not touch the wall or

other units and there is air circulation below the

appliance.

2. Loosen or tighten the feet to adjust the level.

All feet must rest firmly on the floor.

Warning! Do not put

cardboard, wood or

equivalent materials below

the appliance feet to adjust

the level.

The inlet hose

Caution! Make sure there is

no damage to hoses and there

are no leaks from the

couplings. Do not use an

extension hose if the inlet

hose is too short. Contact the

service centre for a

replacement inlet hose.

Washer Dryer User Manual 11