User manual

Daily use - Washing & Drying
Warning! Refer to Safety
chapters.
This appliance is an automatic
washer dryer.
NON-STOP programme -
Wash and dry
Not all programmes are
compatible with drying function.
The 1h wash & dry 1kg programme
is already a complete wash&dry
programme.
You can wash and dry your laundry setting a
«non stop-programme». Proceed as follows:
1. Press the On/Off button for some seconds to
activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in the
appropriate compartment.
4. Turn the programme dial to the washing
programme. The appliance defaults to the
washing only mode and the indicator of the
Mode - Wash button is on. The display shows
the default temperature and spin. If necessary,
change them according to your laundry. The
display also shows the maximum
recommended load for washing phase.
5. Set the desired options, if there are available.
6. Tap on the Mode - Dry button to activate also
the drying function. Both indicators of the
Mode - Wash and Mode - Dry buttons are on.
The indicators
and appear on the
display. The display also shows the maximum
recommended load for a washing and drying
programme (e.g. 4 kg for cottons).
Washing and Drying -
Automatic levels
1. Tap on the Auto dry button repeatedly until
the display shows the required dryness level.
The indicators in the display illuminate
accordingly:
a. Iron dry: for cotton items;
b. Cupboard dry: for cotton and
synthetic items;
c.
Extra dry: for cotton items.
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load size.
To have a good drying by using less
energy and in a shorter time, the
appliance does not let you set a
too low spin speed for the items to
be washed and dried.
2. Touch the Start/Pause button to start the
programme. The SensiCare estimation starts.
In the display the door locked indicator
comes on.
The display also shows the remaining
programme time.
Washing and Timed Drying
1. Tap on the Time dry button repeatedly to set
the desired time value (see the "Timed drying"
table the "Programmes" chapter). The drying
level indicator
goes off and the indicator
comes on.
Each time you tap on this button the time value
increases by 5 minutes. The display shows the
set new time value.
2. Touch the Start/Pause button to start the
programme. The SensiCare estimation starts.
Washer Dryer User Manual
36