32972411.qxd 07/12/2007 11.
132972411.qxd 07/12/2007 11.16 Pagina 2 Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings.
132972411.qxd 07/12/2007 11.16 Pagina 3 Maintenance and Cleaning ● Environmental Information For information on maintenance and cleaning your washing machine see pages 24 - 25 of this instruction manual. ● ● Service ● This product should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used. ● After unpacking please dispose of packaging with due regard to safety and the environment. Materials marked with the symbol are recyclable.
132972411.qxd 07/12/2007 11.
132972411.qxd 07/12/2007 11.
132972411.qxd 07/12/2007 11.16 Pagina 6 Installation It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
132972411.qxd 07/12/2007 11.16 Pagina 7 Unpacking Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. All transit bolts and packing must be removed before using the appliance. Keep all packaging away from children. You are advised to keep all the transit bolts for re-use in case the machine is to be transported again.
132972411.qxd 07/12/2007 11.16 Pagina 8 Plumbing In 4. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. 5. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Your new washing machine has been designed to be permanently plumbed in to your home’s water supply and drainage system.
07/12/2007 ½ 11.16 Pagina 9 38 mm (½) standpipe diameter 30 cm (12") 132972411.qxd P1197 HEC0013 Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine. When discharging into a standpipe ensure that the top of the standpipe is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level. Max. 90 cm (35.4) Min. 60 cm (23.
132972411.qxd 07/12/2007 11.16 Pagina 10 Some vibration is inevitable, especially if mounted on a wooden floor. Sprung wooden floors are particularly susceptible to vibration. For advice, consult a builder. If possible, always place the machine on a solid floor. In the interest of the environment Washing machines and dishwashers should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river.
132972411.qxd 07/12/2007 11.16 Pagina 11 Electrical connection GREEN & YELLOW E 13 A Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. N WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see page 27).
132972411.qxd 07/12/2007 11.
2972411.qxd 07/12/2007 11.16 Pagina 13 Programme options buttons - Select “Spin” programme. Select the spin speed by means of the relevant button and then press the “Start/Pause” button. The water is emptied out and the laundry is spun at the selected spin speed. Attention! Before selecting the “Drain” programme or “Spin” programme the selector dial must first be turned to the «Off» position. Depending on the programme, different options can be selected together.
132972411.qxd 07/12/2007 11.16 Pagina 14 2.00 The delay time (20 hours max) is displayed for 3 seconds, then the duration of the selected programme reappears. After you have pressed the Start/Pause button, the countdown is updated every hour, and, for the last hour, every minute. 8 Display (Wash time) The following pieces of information are shown on the display: ● Duration of washing programme in hours and minutes, after you have selected a programme.
132972411.qxd 07/12/2007 11.16 Pagina 15 If an incorrect option is selected, the red pilot light for the Start/ Pause button flashes 3 times and the message Err is displayed for about 2 seconds. Important! You must set the washing machine to Pause before you make any change in the programme in progress. The wash programme can be delayed from 30 min 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button.
132972411.qxd 07/12/2007 11.16 Pagina 16 Programme information Soak Spin This is a special programme for heavily soiled laundry. The machine performs a soak for about 30 minutes at 30°C. Pour the detergent for the soak programme into the compartment marked . At the end of the soak time the machine will stop automatically with water left in the tub. The display will show a flashing zero. The “Door lock” light is on.
132972411.qxd 07/12/2007 11.16 Pagina 17 Using the washing machine 3.Measure out the fabric softener Before the first wash, we recommend that you pour 2 litres of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at 90°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the dispenser drawer and start the machine.
132972411.qxd 07/12/2007 11.16 Pagina 18 6. Select the spin speed or “None” option 9. Select the “Delay start” Before you start the programme, if you wish the start to be delayed, press the “Delay Start” button repeatedly, or keep it pressed, to select the desired delay. The selected delay time value (up to 20 hours) will appear on the display for 3 seconds, then the duration of the programme will appear again.
132972411.qxd 07/12/2007 11.16 Pagina 19 12.How to interrupt a programme 14. End of programme At the end of the programme, the washing machine stops automatically, the “Start/Pause” button light and the “Door” light go off, the display shows a flashing zero «0». It is possible to open the door. If you had selected the “Rinse hold” option, the “Rinse Hold” light and the “Door lock” light remain lit to indicate that the door is locked and the water must be drained.
132972411.qxd 07/12/2007 11.16 Pagina 20 Hints & tips on washing ● Do NOT overload the machine. Weigh the laundry the first few times you use the appliance.
132972411.qxd 07/12/2007 11.16 Pagina 21 Wash care symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labelling code is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correct programme on your washing machine.
132972411.qxd 07/12/2007 11.16 Pagina 22 Washing programmes Fabrics Programme/ temperature 90° White cotton Cottons White cotton 90° Cottons + INTENSIVE Available options Load Sheets, household linen, towels, tablecloths Spin reduction/None Prewash, Intensive, Rinse hold, Stain, Extra rinse, Quick 6Kg 2.0 61 Sheets, household linen, towels, tablecloths Spin reduction/None Prewash, Stain, Rinse hold, Extra rinse 6 Kg 2.
132972411.qxd 07/12/2007 11.16 Pagina 23 Washing programmes Programme Programme description Soak Soak for 30 minutes at 30°C Rinse 3 rinses Long spin at max. speed Consumptions* Load Energy kWh Water litres 6 Kg 0.4 21 Spin reduction/ None, Rinse hold Extra rinse 6 Kg 0.1 42 - 6 Kg - - Available options Drain For emptying out the last rinse of the programmes Water draining with option “Rinse hold” and programme “Soak” Spin Drain and long spin at max.
132972411.qxd 07/12/2007 11.16 Pagina 24 Maintenance and cleaning You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Do this separately from any laundry washing, and according to the softening powder manufacturer's instructions. This will help to prevent the formation of lime deposits.
132972411.qxd 07/12/2007 11.16 Pagina 25 • When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dry up spillage of water when removing the cover. Tighten up the inlet hose. P1090 The dangers of freezing P1115 If the machine is exposed to temperatures below 0°C, certain precautions should be taken. ● Turn off the water tap. ● Unscrew the inlet hose.
132972411.qxd 07/12/2007 11.16 Pagina 26 Something not working Please carry out the following checks before contacting your local Service Force agent. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
132972411.qxd 07/12/2007 11.16 Pagina 27 Symptom Solution The machine vibrates when spinning ● ● ● ● ● The door will not open The internal packing has not been removed. The machine is in contact with the wall or furniture. The machine is not level and stable (check diagonally). The washing load is badly distributed in the drum. Maybe there is very little laundry in the drum. ● The water level is above the bottom edge of the door. The machine is heating the water. ● The drum is turning.
132972411.qxd 07/12/2007 11.16 John Lewis Partnership 171 Victoria Street London SW1E 5NN www.johnlewis.
