User manual

4. When the container is full of water, put the
drainage duct back again and empty the
container. Do steps 3 and 4 again and again
until no more water flows out from the
drain pump.
5. Pull back the drainage duct and turn the
filter to remove it.
1
2
6. Remove fluff and objects from the pump.
7. Make sure that the impeller of the pump
can turn. If this does not occur, contact the
service centre.
8. Clean the filter under the water tap and put
it back in the pump into the special guides.
9. Make sure that you tighten correctly the
filter to prevent leakages.
2
1
10. Close the drain pump door.
The inlet hose filter and the valve
filter
It could be necessary to clean the filters when:
• The appliance does not fill with water.
• The appliance fills with the water for a long
time.
•
The indicator of button 4 flashes and the
display shows the related alarm. Refer to
'Troubleshooting'.
Warning! Disconnect the mains
plug from the mains socket.
Cleaning the water inlet filters:
1. Close the water tap.
2. Remove the water inlet hose from the
water tap.
3. Clean the filter in the inlet hose with a stiff
brush.
Washing Machine user manual 25