User manual

1
2
3
4. Remove the inlet hose behind the
appliance.
5. Clean the filter in the valve with a stiff brush
or a towel.
6. Install again the inlet hose. Make sure that
the couplings are tight to prevent leakages.
45°
20°
7. Open the water tap.
Emergency emptying out
If the appliance cannot drain the water, proceed
as follows to empty out the machine:
1. Pull out the plug from the power socket;
2. Close the water tap;
3. If necessary, wait until the water has cooled
down;
4. Open the pump door;
5. Place a container on the floor below the
recess of the drain pump;
6. Press the two levers and pull forward the
drainage duct to let the water flow out;
7. When the container is full of water, put the
drainage duct back again and empty the
container;
Repeat this operation until water stops
flowing out;
8. If necessary clean the pump (refer to the
section ‘Drain pump’ );
9. Close the drain pump door.
When you drain the water with the emergency
drain procedure, you must activate again the
drain system:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.
Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, remove the
remaining water from the inlet hose and the
drain pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap
3. Unscrew the water inlet hose from the tap;
4. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
5. Empty the drain pump as described in the
‘Emergency emptying out ’ section.
6. When the drain pump is empty, install the
water inlet hose again.
Warning!
26 Washing Machine user manual