User manual

Problem Possible cause Possible solution
The appliance door is
open or not closed
correctly.
Close the door correctly.
The spin phase does not
operate.
The spin phase is off. Set the spin programme.
The filter of the drain pump is
blocked.
Clean the filter of the drain pump. Refer to
'Care and cleaning'.
Balance problems with the laundry
load.
Adjust manually the items in the tub and start
the spin phase again.
The programme does not
start.
The mains plug is not connected in
the mains socket.
Put in the mains plug.
Blow out fuse in the household
fuse box.
Replace the fuse.
You did not press button 4. Press button 4.
The delay start is set. To start immediately the programme, cancel
the delay start.
The Child Lock function is
activated.
Deactivate the Child Lock function.
There is water on the
floor.
Leakages from the couplings of the
water hoses.
Make sure that the couplings are tight.
Leakages from the drain pump. Make sure that the drain pump filter is tight.
The drain hose or the inlet hose is
damaged.
Make sure that the inlet or the drain hose has
no damages.
You cannot open the
appliance door.
The washing programme is in
operation.
Let the washing programme end.
There is water in the drum. Set the drain or the spin programme.
The appliance makes an
unusual noise.
Incorrect level of the appliance. Adjust the level of the appliance. Refer to
'Installation'.
You did not remove the packaging
and/or the transit bolts.
Remove the packaging and/or the transit
bolts. Refer to 'Installation'.
The load is very small. Add more laundry in the drum.
The appliance fills with
water and drain
immediately.
The end of the drain hose is too
low.
Make sure that the drain hose is in the
correct position.
The cycle is shorter than
the time displayed.
The appliance calculates a new
time according to the laundry
load.
See the ‘Consumption Values’ chapter.
The cycle is longer than
the time displayed.
An unbalanced laundry load
increases the duration time.
This is a normal behaviour of the appliance.
34 Washing Machine user manual