- Electrolux Ceramic Glass Induction Hob Instruction manual

Electrical Connection

1 This hob must be earthed.

Electrical Requirements

Any permanent electrical installation must comply with the

latest I.E.E. Regulations and local Electricity Board regula-

tions. For your own safety this should be undertaken by a

qualified electrician, e.g. your local Electricity Board, or a

contractor who is on the roll of the National Inspection

Council for Electrical Installation Contracting (NICEIC).

Electrical Connection

The hob is designed to be connected to 230 V (50 Hz) elec-

tricity supply. Before connecting to the mains supply ensure

that the mains voltage corresponds to the voltage on the

rating plate underneath the hob.

For UK only

It is necessary that you install a double pole switch between

the hob and the electricity supply (mains), with a minimum

gap of 3 mm between the switch contacts and of a type suit-

able for the required load in compliance with the current

rules.

1 The switch must not break the yellow and

green earth cable at any point.

It is necessary that the yellow / green earth

wire is about 2 cm longer than the live and

neutral ones.

Important

After installation and connecting, the cable must be placed

so that it cannot at any point reach a temperature of more

than 60°C above the ambient temperature.

Before the hob is connected, check that the main fuse and

the domestic installation can support the load; and that the

power supply is properly earthed.

The manufacturer disclaims any responsibility should these

safety measures not be carried out.