Instructions / Assembly

MNEZ123 072916
– 20 –
Model EZ-1/2/3 oil burners — Instruction manual
For other than routine maintenance, con-
tact a qualied service company. Perform
the following as needed.
• Keep the area around the burner clear
and free from combustible vapors and
liquids.
• Do not obstruct the ow of combustion
and ventilating air.
• Most motors currently used on resi-
dential type burners use permanently-
lubricated bearings, and do not require
eld lubrication. Read the label on the
motor to determine oiling needs, if any.
Do not over-lubricate. This can cause
as much trouble as not lubricating at all.
Never attempt to use gasoline as
a fuel for this burner, as it is more
combustible and could result in
a serious explosion. Never at-
tempt to burn refuse or use any
fuel other than #1 or #2 heating
oil (ASTM D396).
EZ-1/2/3 Oil Burner
User Care and Maintenance
Refer only to the information on
this page, intended for your use.
The remainder of this manual is
intended only for your service techni-
cian. Failure to comply could result
in severe personal injury, death or
substantial property damage.
Should overheating occur:
1. Shut off the oil supply to the burner.
2. DO NOT shut off the control switch to
the circulator or blower.
3. Contact your oil dealer or service
technician and the re department (if
needed).
The burner must be cleaned, tested and
adjusted annually by a qualied oil burner
service technician.