User's Guide Part 3

6 – 30
Maintenance and Care
Owner Maintenance
Battery Replacement
If the buttons on the transmitter are
inoperable and the operation indicator
light does not fl ash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
CAUTION

Make sure the battery is installed
correctly. Battery leakage could occur if
it is not installed correctly.

When replacing the battery, be careful
not to touch any of the internal circuitry
and electrical terminals, bend the
electrical terminals, or get dirt in the
transmitter as the transmitter could be
damaged.

There is the danger of explosion if the
battery is not correctly replaced.

Dispose of used batteries according to
the following instructions.

Insulate the plus and minus terminals
of the battery using cellophane or
equivalent tape.

Never disassemble.

Never throw the battery into  re or
water.

Never deform or crush.

Replace only with the same type battery
(CR2025 or equivalent).
The following conditions indicate that the
battery power is low:
• The KEY indicator light (green) flashes
in the instrument cluster for about 30
seconds after the engine is turned off.
• The system does not operate and
the operation indicator light on the
transmitter does not flash when the
buttons are pressed.
• The system's operational range is
reduced.
Replacing the battery at an Authorized
Mazda Dealer is recommended to prevent
damage to the key. If replacing the battery
by yourself, follow the instruction below.
Replacing the key battery
1. Pull out the auxiliary key.
2. Insert a small, fl athead screwdriver
into the groove shown in the fi gure and
rotate the screwdriver to open the cover
slightly.
Mazda3_8CX9-EA-13F_Edition1.indb 30Mazda3_8CX9-EA-13F_Edition1.indb 30 2013/05/17 11:51:532013/05/17 11:51:53