User Manual

HomeLink and the HomeLink house are registered trademarks of Johnson Controls, Inc.
In the event that there are still programming difficulties or questions, please review the training
video listed at the YouTube.com
location listed below.
Erasing HomeLink Buttons
To erase programming from the three buttons (individual buttons cannot be erased but can be
“reprogrammed” as outlined below), follow the step noted:
 Press and hold the two outer HomeLink buttons until the indicator light
begins to flash-after 10 seconds. Release both buttons. Do not hold for
longer that 20 seconds. HomeLink is now in the train (or learning) mode
and can be programmed at any time beginning with “Programming” - step 1.
Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink button previously trained, follow these
steps:
1. Press and hold the desired HomeLink button. DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the
HomeLink button, proceed with “Programming” - step 1
For questions or comments, contact HomeLink at: www.homelink.com
or 1–800–355–3515.
For video training directions, please refer to the following YouTube location.
#1) Seach for YouTube.com
#2) Then search for HomeLinkInstruction’s channel
#3) Select the video HomeLink Programming Instructions – Garage Door Opener