Installation Manual
4 | (215) 788-8485
This manual is a comprehensive guide for the installaon and wiring
of your H2O Degree T-1000 thermostat.
Step 1.1: Turn o the power at the circuit breaker to both
your heang and cooling systems before performing any
wiring.
Step 1.2: Conrm that your heang
and cooling system is powered down by changing the
temperature on your exisng thermostat. The heang
and cooling should not come on but may show the
temperature change on your exisng thermostat.
Note: Your system should not make any noise and you
should not feel any air exing your vents.
Step 1.3: Remove the front of your old thermostat
from its base.
If you see thick black wires, wire nuts, or any labels
that say 120-240VAC or High Voltage, your system
is not compable with the T-1000 thermostat.
Please call H2O Degree technical support at (215) 788-8485 before
proceeding with your installaon. If you do not see any high voltage
labels or wires, you may connue with the installaon process.
HIGH
VOLTAGE
STOP