User Guide

M9000-560 Ball Valve Linkage Kit and M9000-561 Thermal Barrier Installation Instructions 9
Mounting M9000-560 Linkage to M9208
Actuator
To mount the actuator to a ball valve rotate the valve
stem manually several times using an adjustable
wrench to break the torque that may have built up
during long-term storage.
Mounting the M9208 Actuator to Spring Return Port
A (Coil) Open
To mount the actuator to Spring Return Port A (Coil)
open:
1. Turn the valve stem to the position outlined in
Figure 18.
2. Mount optional M9000-561 Thermal Barrier to the
valve if fluid temperature exceeds 212°F (100°C).
See the Mounting the Thermal Barrier
section for
more information.
3. Insert the drive shaft into Side B (Figure 19).
4. Install linkage base on Side B using the two
#10-14 x 2.75 in. long screws (Figure 20). The
recommended torque is 20 to 24 lb·in.
(2.3 to 2.7 N·m).
5. Insert fixed pointer and M4x0.7x83 mm long screw
into the Side A actuator hub. Direct the arrow on
the pointer to 100%.
Figure 18: Positioning the Valve Stem
F
I
G
:
V
G
1
0
0
0
3 Way2 Way
Figure 19: Inserting the Drive Shaft
F
I
G
:
D
R
V
_
S
H
F
T
_
B
Figure 20: Installing the Linkage
Figure 21: Installing the Fixed Pointer
F
I
G
:
F
X
P
T
_
A