Product Overview

TE-6300 Series Temperature Sensors Product Bulletin6
Ordering Information
To order a TE-6300 Series temperature sensor,
contact the nearest Johnson Controls representative.
Specify the desired sensor product code number from
Table 4 and accessories from Table 5, depending on
the model.
Note: Use the TE-63xxM or TE-63xxV model to meet
plenum requirements where UL1995 rating is
accepted, or replace the existing plastic cover on the
TE-63xxP models with the TE-6001-13 Metal Cover
Kit.
Use the TE-63xxM model and a TE-6300-613
Accessory Kit to replace the plastic bushing to meet
International Mechanical Code (IMC) requirements.
Note: Not all possible combinations are available. See Table 4 for available models.
Wall Mount N/A 1k ohm Thin-Film
Nickel
1k ohm Thin-Film
Platinum
2.2k ohm Thermistor
• Use to sense room or space temperature.
• Order an accessory cover with a thermometer or to match the style of
existing installations.
• Mount the sensor on an inside wall, out of direct sunlight and away from
radiant heat.
Well
Insertion
Probe
6 (152)
8 (203)
1k ohm Thin-Film
Nickel
1k ohm Thin-Film
Platinum
2.2k ohm Thermistor
10k ohm Thermistor
Type II
• Available with plastic or metal enclosure.
• Threaded sensor holder has 1/2-14 NPT threads; threadless holder
accommodates setscrew-type wells.
• Mount the thermal well at an angle so condensation runs out of the well.
If not possible, seal the sensor holder and the wiring end of the sensor
probe with RTV silicone sealant.
• Use TE-63xxM models for plenum applications.
• Use TE-6001-13 metal cover kit with TE-63xxP models to meet UL 1995
plenum requirements.
• Use the accessory 12 in. (305 mm) probe with the TE-63xxP sensor in
longer wells.
• Order compatible thermal wells, using Table 5 and Table 6 or Table 7.
Table 3: TE-6300 Series Temperature Sensor Applications (Part 2 of 2)
Application Nominal
Probe
Length,
in. (mm)
Sensor Type Application Notes
Figure 5: Ordering Template
T E — 6 3
—
xxx
Suffix
Probe Style
Enclosure Type
Sensor Type
FIG: ord_temp