Product Overview

Published in U.S.A. www.johnsoncontrols.com
TE-63xS Series Strap-Mount Temperature Sensors Installation Instructions2
Metasys® and Johnson Controls® are registered trademarks of Johnson Controls, Inc.
All other marks herein are the marks of their respective owners. © 2010 Johnson Controls, Inc.
Building Efficiency
507 E. Michigan Street, Milwaukee, WI 53202
The 10k ohm thermistor applications tolerate relatively
long wiring before the wire resistance adds significantly
to total resistance measured at the controller. As a
general rule, a 150 ft (46 m) two-wire 18 AWG
(1.0 mm diameter) run contributes 2 ohms of error, or
less than 1F° (0.56C°) error over the sensor operating
temperature range.
Refer to the appropriate controller documentation for
recommended sensor wiring.
Repair Information
If the TE-63xS Series Strap-Mount Temperature
Sensor fails to operate within its specifications, replace
the unit. For a replacement sensor, contact the nearest
Johnson Controls
® representative.
Technical Specifications
The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these
specifications, consult the local Johnson Controls office. Johnson Controls, Inc. shall not be liable for damages resulting from misapplication or
misuse of its products.
!
CAUTION: Risk of Property Damage.
Do not apply power to the system before
checking all wiring connections. Short
circuited or improperly connected wires
may result in permanent damage to the
equipment.
IMPORTANT: Use copper conductors only. Make
all wiring connections in accordance with local,
national, and regional regulations. Do not exceed
the TE-63xS Series Strap-Mount Temperature
Sensor’s electrical ratings.
TE-63xS Series Strap-Mount Temperature Sensors
Models TE-631S-1 1k ohm Thin-Film Nickel Temperature Sensor
TE-635S-1 1k ohm Thin-Film Platinum Temperature Sensor
TE-636S-1 10k ohm Thermistor Johnson Controls Type II Temperature Sensor
Sensor Reference
Resistance
1k ohm Nickel 1k ohms at 70°F (21°C)
1k ohm Platinum 1k ohms at 32°F (0°C)
10k ohm Thermistor 10.0k ohms at 77°F (25°C)
Sensor Accuracy 1k ohm Nickel ±0.34F° at 70°F (±0.19C° at 21°C)
1k ohm Platinum ±0.35F° at 70°F (±0.19C° at 21°C), DIN Class A
10k ohm Thermistor ±0.9F° (±0.5C°) in the Range: 32 to 158°F (0 to 70°C)
Sensor Temperature
Coefficient
1k ohm Nickel Approximately 3 ohms/F° (5.4 ohms/C°)
1k ohm Platinum Approximately 2 ohms/F° (3.9 ohms/C°) 3850 ppm/K
10k ohm Thermistor Nonlinear Negative Temperature Coefficient, Johnson Controls Type II
Electrical Connections 22 AWG (0.6 mm Diameter) x 10 ft (3 m) Long Plenum-Rated Cable,
White Leads
Probe Materials 1/4 in. (6.4 mm) Outside Diameter x 3 in. (76 mm) Stainless Steel
Operating Temperature
Limits
Cable -50 to 140°F (-46 to 60°C)
Probe -50 to 220°F (-46 to 104°C)