Actuator Install Instructions

ManualsBrandsJohnson Controls ManualsDampers2-Way Normally Open 1/2" VG7000 Series Brass Trim Globe Valve w/ V3000 Pneumatic Actuator

The performance specifications are nominal and conform to acceptable industry standards. For applications at conditions beyond these specifications, consult the local Johnson Controls office.

www.johnsoncontrols.com

1 of 1

V-3000 Series

Pneumatic Actuator

Description

The V-3000 Pneumatic Actuator can position

steam or water valve-modulating plugs in

response to a pneumatic signal from a

controller.

Refer to V-3000 Pneumatic Valve Actuator

Exposed or Enclosed Product Bulletin (LIT-

977250) for important product information.

Features

• molded synthetic rubber diaphragm design

provides a constant effective area

throughout the valve stem stroke

• die cast aluminum housing coated with

corrosion-resistant finish

• remove or reposition actuator by loosening

a single set screw

• easily field mounted to the valve bonnet

with a single set screw.

• can be mounted to any of the V-3000,

V-4000, or VT Series Valves

(except V-3854)

Applications

Used on 1/2 in. Flare Valves, VT Series

Valves, and 3/4 to 1-1/2 Cage Trim Valves.

This actuator is not used with VG7000 Series

valves.

Repair Information

If the V3000 Series Pneumatic Actuator fails to

operate within its specifications, replace the

unit. For a replacement actuator, contact the

nearest Johnson Controls® representative.

Code No. LIT-1924055

Issued January 15, 2008

Selection Charts

V-3000 Series Pneumatic Actuator

Code Number Description

V-3000-1 Exposed Yoke

Accessories for Exposed Model V-3000 (Order Separately)

Code Number Description

V-3000-10 Valve Position Indicator

V-9502-15 Positioner Kit

1. Refer to V-9502 Series Pneumatic Valve Actuator Positioners Catalog Page

(LIT-1924100).

Exposed V-3000-1 Actuator

Technical Specifications

V-3000 Series Actuators

Media Temperature 281°F Maximum

Maximum Control

Pressure

30 psig

Available Spring

Ranges

1. A spring is assembled with the valve body, not in the actuator.

For spring kits to field mount V-3000-1 to valve bodies, refer to Valve Spring

Kits Sorted by Valve Code Number Catalog Page (LIT-1924395).

3-6, 4-8, and 9-13 psig

Air Connection 1/8 in. NPT Barbed Fitting for 5/32 in. O.D. Polytubing

Size (in.) 3 H x 4-7/16 Diameter

Summary of content (1 pages)

PAGE 1
Code No. LIT-1924055 Issued January 15, 2008 V-3000 Series Pneumatic Actuator Description Applications The V-3000 Pneumatic Actuator can position steam or water valve-modulating plugs in response to a pneumatic signal from a controller. Used on 1/2 in. Flare Valves, VT Series Valves, and 3/4 to 1-1/2 Cage Trim Valves. This actuator is not used with VG7000 Series valves. Refer to V-3000 Pneumatic Valve Actuator Exposed or Enclosed Product Bulletin (LIT977250) for important product information.