Operator's Manual
Table Of Contents
- Table of Contents
- 1 — Introduction
- 2 — Warnings, Cautions, and Other Residual Risks
- 3 — System Components
- 4 — Surgery Start Up
- 5 — Surgeon Settings
- 6 — Program Settings
- 7 — System Configuration
- Setting the Maximum IV Pole Height
- Testing the IV Pole
- Event Log
- Wireless Foot Pedal Setup
- VERITAS Remote Control Setup
- System Versions
- System Self Test
- Language Selection
- Surgical Media Center (SMC) (Optional)
- Set System Date and Time
- Set Units of Measure for Vacuum
- Service Interval
- Import/Export Database
- Backup All
- Print to File
- Restore Database
- Restore All
- Delete a Backup Database
- 8 — Symbol Definitions
- 9 — Care and Cleaning
- 10 — Error Messages, Troubleshooting, and Diagnostics
- 11 — Warranty and Maintenance
- 12 — Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Electromagnetic Compatibility
- RF Wireless Technology
- Bluetooth Characteristics
- Phacoemulsification Specifications
- Irrigation and Aspiration Specifications
- Vitrectomy Specifications
- Diathermy Specifications
- Diathermy Power Graphs
- Diathermy Power versus Load Impedance
- Phaco Power Graphs
- Phaco Tip Velocity
- Bottle Height Pressure
- 13 — Accessories and Parts Reordering
- Index
Z370584 Rev.C
7-1
7 — System Configuration
• “Setting the Maximum IV Pole Height” on page 7-1
• “Testing the IV Pole” on page 7-2
• “Event Log” on page 7-3
• “Wireless Foot Pedal Setup” on page 7-4
• “VERITAS Remote Control Setup” on page 7-9
• “System Versions” on page 7-10
• “System Self Test” on page 7-12
• “Language Selection” on page 7-13
• “Surgical Media Center (SMC) (Optional)” on page 7-14
• “Set System Date and Time” on page 7-16
• “Set Units of Measure for Vacuum” on page 7-17
• “Service Interval” on page 7-18
• “Import/Export Database” on page 7-20
• “Backup All” on page 7-23
• “Print to File” on page 7-24
• “Restore Database” on page 7-24
• “Restore All” on page 7-26
• “Delete a Backup Database” on page 7-28
Setting the Maximum IV Pole Height
Follow these steps to set the maximum IV pole height.
NOTE: The Configuration screen is only available when you are not in a case. If you need to
access the Configuration screens you must select End Case, select Next Case, then
tap the Configuration button.
1. Tap Configuration.
2. Tap the Max IV Pole Height button.