Operator's Manual
Table Of Contents
- Table of Contents
- 1 — Introduction
- 2 — Warnings, Cautions, and Other Residual Risks
- 3 — System Components
- 4 — Surgery Start Up
- 5 — Surgeon Settings
- 6 — Program Settings
- 7 — System Configuration
- Setting the Maximum IV Pole Height
- Testing the IV Pole
- Event Log
- Wireless Foot Pedal Setup
- VERITAS Remote Control Setup
- System Versions
- System Self Test
- Language Selection
- Surgical Media Center (SMC) (Optional)
- Set System Date and Time
- Set Units of Measure for Vacuum
- Service Interval
- Import/Export Database
- Backup All
- Print to File
- Restore Database
- Restore All
- Delete a Backup Database
- 8 — Symbol Definitions
- 9 — Care and Cleaning
- 10 — Error Messages, Troubleshooting, and Diagnostics
- 11 — Warranty and Maintenance
- 12 — Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Electromagnetic Compatibility
- RF Wireless Technology
- Bluetooth Characteristics
- Phacoemulsification Specifications
- Irrigation and Aspiration Specifications
- Vitrectomy Specifications
- Diathermy Specifications
- Diathermy Power Graphs
- Diathermy Power versus Load Impedance
- Phaco Power Graphs
- Phaco Tip Velocity
- Bottle Height Pressure
- 13 — Accessories and Parts Reordering
- Index
System Versions Z370584 Rev. C
7-10
System Configuration
If the green light remains off after button presses, remove the back battery cover to
replace or install batteries (2x AA DURACELL
®
COPPERTOP). See “Battery
Replacement – VERITAS Remote Control” on page 10-4.
If the amber light is on, the remote battery is low. Replace batteries to ensure optimal
performance. See “Battery Replacement – VERITAS Remote Control” on page 10-4.
If the blue light is on, the VERITAS Remote Control is paired.
If the blue light is blinking fast, the VERITAS Remote Control is searching for a
connection.
If the blue light is off, the VERITAS Remote Control is not paired.
6. When pairing completes, the system displays a green checkmark and the remote battery
percentage.
7. Test the VERITAS Remote Control or tap Finished to close the test screen.
8. Tap Exit to close the Configuration screen.
NOTE: If you have problems pairing the VERITAS Remote Control, remove any other
Bluetooth devices from the area. Multiple Bluetooth devices can affect the pairing
process.
Wireless VERITAS Remote Control Test
1. On the main screen, tap Configuration.
2. Tap Wireless Remote Test.
3. Follow the instructions on the screen.
4. Tap to refresh the battery status for the VERITAS Remote Control.
5. Tap Finished to close the dialog box.
6. Tap Exit to close the Configuration screen.
System Versions
Displays the software and firmware versions of the system.
1. On the main screen, tap Configuration.
2. Tap System Versions.