Operator's Manual
Table Of Contents
- Table of Contents
- 1 — Introduction
- 2 — Warnings, Cautions, and Other Residual Risks
- 3 — System Components
- 4 — Surgery Start Up
- 5 — Surgeon Settings
- 6 — Program Settings
- 7 — System Configuration
- Setting the Maximum IV Pole Height
- Testing the IV Pole
- Event Log
- Wireless Foot Pedal Setup
- VERITAS Remote Control Setup
- System Versions
- System Self Test
- Language Selection
- Surgical Media Center (SMC) (Optional)
- Set System Date and Time
- Set Units of Measure for Vacuum
- Service Interval
- Import/Export Database
- Backup All
- Print to File
- Restore Database
- Restore All
- Delete a Backup Database
- 8 — Symbol Definitions
- 9 — Care and Cleaning
- 10 — Error Messages, Troubleshooting, and Diagnostics
- 11 — Warranty and Maintenance
- 12 — Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Electromagnetic Compatibility
- RF Wireless Technology
- Bluetooth Characteristics
- Phacoemulsification Specifications
- Irrigation and Aspiration Specifications
- Vitrectomy Specifications
- Diathermy Specifications
- Diathermy Power Graphs
- Diathermy Power versus Load Impedance
- Phaco Power Graphs
- Phaco Tip Velocity
- Bottle Height Pressure
- 13 — Accessories and Parts Reordering
- Index
Z370584 Rev. C
8-1
8 — Symbol Definitions
The following symbols appear on the VERITAS
™
Vision System front and back panels and in
the software:
Symbol Definition
Symbol on the power switch indicates power is on.
Symbol on the power switch indicates power is off.
Symbol on the Power On/Off button. If the system is in power down mode,
pressing this button will cause the system to power up. If the system is powered,
pressing this button for a short duration will cause the system to display a
shutdown confirmation screen on touchscreen monitor. If the button is pressed
for a long time, the system will enter power-down mode without any on-screen
prompt.
Brazilian National Institute of Metrology, Standardization and Industrial Quality
(INMETRO)
Product Certification Body (OCP) - TÜV Rheinland do Brasil Ltda.
Indicates fuse.
Single phase alternating current.
Indicates isolation of the patient applied part from earth ground.