Operator's Manual
Table Of Contents
- Table of Contents
- 1 — Introduction
- 2 — Warnings, Cautions, and Other Residual Risks
- 3 — System Components
- 4 — Surgery Start Up
- 5 — Surgeon Settings
- 6 — Program Settings
- 7 — System Configuration
- Setting the Maximum IV Pole Height
- Testing the IV Pole
- Event Log
- Wireless Foot Pedal Setup
- VERITAS Remote Control Setup
- System Versions
- System Self Test
- Language Selection
- Surgical Media Center (SMC) (Optional)
- Set System Date and Time
- Set Units of Measure for Vacuum
- Service Interval
- Import/Export Database
- Backup All
- Print to File
- Restore Database
- Restore All
- Delete a Backup Database
- 8 — Symbol Definitions
- 9 — Care and Cleaning
- 10 — Error Messages, Troubleshooting, and Diagnostics
- 11 — Warranty and Maintenance
- 12 — Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Electromagnetic Compatibility
- RF Wireless Technology
- Bluetooth Characteristics
- Phacoemulsification Specifications
- Irrigation and Aspiration Specifications
- Vitrectomy Specifications
- Diathermy Specifications
- Diathermy Power Graphs
- Diathermy Power versus Load Impedance
- Phaco Power Graphs
- Phaco Tip Velocity
- Bottle Height Pressure
- 13 — Accessories and Parts Reordering
- Index
Z370584 Rev. C
8-6
Symbol Definitions
Clear Error – Only active when there is an error. Tap this icon after resolving the
error. The icon removes the error from the display.
Event Log – Tap this button on the Configuration screen to view the Event Log.
Max IV Pole Height – Tap this button on the Configuration screen to set the
maximum height the IV pole can move.
Wireless Setup – Tap this button on the Configuration screen to pair the wireless
VERITAS Remote Control or the wireless foot pedals.
View System Versions – Tap this button on the Configuration screen to view the
version of the software and firmware installed on the system.
IV Pole Test – Tap this button on the Configuration screen to test the movement
of the IV pole.
Wireless Remote Test – Tap this button on the Configuration screen to test the
functionality of the VERITAS Remote Control.
System Self Test – Tap this button on the Configuration screen to run a test of the
system.
Set Date/Time – Tap this button on the Configuration screen to set the date and
time.
Symbol Definition